20 Most Recent Jacuzzi Amiga, Soaking Bathtub with Integral Skirt - T715 - Page 8 Questions & Answers

0helpful
2answers

How to repace switch button

Air Switch Repair It sounds like you have a bad air switch located in your motor. The air switch is what the air hose connects to on the back of the motor or on the box on top of the motor. The other end of the air hose is connected to the air button on the lip of the tub. This is a latching air switch and when you push the air button it latches and sends the power to the motor. When the air button is pushed again it opens the latch in the air switch and stops power going to the motor shutting it off.
2/16/2015 4:30:21 PM • Jacuzzi Home • Answered on Feb 16, 2015
0helpful
1answer

I have an older Jaccuzzi hot tub w a balboa h136 board and single button topside control. The hot tub will not heat. The LED lights up on low speed and goes off on high speed. I just replaced the heat

You have voltage across the element but no heat.... Disconnect one element connection and do a resistance/continuity test. Or use a clamp to measure running current.
2/13/2015 11:04:52 PM • Jacuzzi Home • Answered on Feb 13, 2015
0answers
0helpful
1answer

How do you replace jacuzzi 3 Position Control Panel Kit?

here is a sheet with instructions that show how to remove the graphic rings that hold the buttons in place.
2/9/2015 8:15:51 PM • Jacuzzi Home • Answered on Feb 09, 2015
0helpful
1answer

Jacuzzi has power but does not work panel has three bars instead of tempeture reading any suggestions

Those 3 bars usually indicate the circuit board is not working properly and will need to be replaced. When you say has 3 bars this is what that shows. - - -
2/9/2015 8:12:26 PM • Jacuzzi Home • Answered on Feb 09, 2015
0helpful
1answer

How to fix jacuzzi tub will not shut off bubbler

if the air blower will not shut off then it will either be the air switch in the blower or the control module that operates the blower will be bad.
2/9/2015 8:10:59 PM • Jacuzzi Home • Answered on Feb 09, 2015
0helpful
1answer

My air bubbles on my Espree Aero Flo modelDS75 are not working why

If the bubbles are not working on the tub it could be the check valve is stuck closed or the air blower is not working.
2/9/2015 8:10:06 PM • Jacuzzi Home • Answered on Feb 09, 2015
0helpful
1answer

I have a jacuzzi whirlpool modelz145, h240000 it keeps running on low never shuts off this just happened never did this before? Bad control board?

Is this an outdoor hot tub? If it is an outdoor hot tub...is it heating up or just running all the time?
2/9/2015 8:09:15 PM • Jacuzzi Home • Answered on Feb 09, 2015
0helpful
1answer

Where can I find parts for this model tub

What kind of parts are you seeking?
2/9/2015 8:08:27 PM • Jacuzzi Home • Answered on Feb 09, 2015
0helpful
1answer

Is it possible to buy somewhere the Optional "U-Frame Skirt" for a "Jacuzzi CIVA Whirlpool" bath tub? Anyone know where or other suggestions on covering the front?

Home Deport and Lowes each used to carry a generic front skirt for "jacuzzi" type tubs. You may find something at one of their stores that will work. The other solution would be to contact a Jacuzzi Showroom for authorized replacement parts.
2/9/2015 8:05:37 PM • Jacuzzi Home • Answered on Feb 09, 2015
0helpful
1answer

I have a jacuzzi whirlpool tub in my home that has started to leak at the three button control panel. Flooded out the bathroom so I cut a hole in the tile surround and when the pump is running it leak

First thing you need to do is remove some skirting so you can actually see where the water is coming from. The 3 position control panel would only leak if the water was above it or covering it if it is located in the wall of the tub. That solution would only require the bather to NOT fill the tub quite so full. IF however the water is coming from another location then that will be noticeable when you are checking for the water leak.
2/9/2015 8:04:15 PM • Jacuzzi Home • Answered on Feb 09, 2015
0helpful
1answer

TIGHTEN JET LEAKING

Check, it sounds like it is cracked.
1/12/2015 1:33:16 AM • Jacuzzi Home • Answered on Jan 12, 2015
0helpful
1answer

I need a replacement flapper for a Jacuzzi toilet x532. HELP!! My zip is 63376

I would take the flapper to your local box store they should be able to help you.
12/10/2014 11:28:41 PM • Jacuzzi Home • Answered on Dec 10, 2014
0helpful
1answer

Newly installed jacuzzi only has hot water for about 30 seconds, then water is tepid only.

This issue will have nothing to do with the jacuzzi tub. You will find the problem exists in the way your home was plumbed by the plumber. Somewhere there is a clog in the water line going to the hot water faucet. Find that and you will solve your problem. Rod US Parts Center
10/6/2014 11:07:44 PM • Jacuzzi Home • Answered on Oct 06, 2014
Not finding what you are looking for?
Jacuzzi Amiga, Soaking Bathtub with Integral Skirt - T715 Logo

Popular Tags

17 questions posted

Ask a Question

Usually answered in minutes!

Top Jacuzzi Home Experts

john h

Level 3 Expert

29494 Answers

Brad Brown

Level 3 Expert

19187 Answers

Gene Lawson

Level 2 Expert

53 Answers

Are you a Jacuzzi Home Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Jacuzzi Home

  • Jacuzzi Home

Most Popular Question

plug part

  • Home
Loading...