Jacuzzi RapidHeat In-Line Heater U395000 [ Bathtubs and Whirlpools, "heating jet pump" Questions

...pump and jets work good, even the air jets work, it is not heating the water though, please help?!!! Sounds like a bad heating element. This is located in a stainless steel tube under or around the ...

...HEATING ELEMENT IS ON AND A SINGLE BUTTON (MEMBRANE TYPE LIKE A MICROWAVE) WHICH CYCLES THROUGH PUMP,JETS W/LIGHT, JETS W/O LIGHT AND OFF. I USED IT ABOUT A WEEK AGO AND TODAY I WENT TO CHECK THE ...

I just installed a new whirlpool jacuzzi tub with an Eljer inline heater. The pump in the tub is shooting water out all the jets I even blew the jets out with air to make sure they were clear. The ...

hot tub mtor is on.....no jets.... Water was green so i drained the hot tub. The tub was drained overnight but what i didnt realize was that it had an automatic filter that came on every hour. So the ...

buttons don't light up to show if it is working or not. i reset the heat button. the heat comes one and goes back out because the pump dose not turn on. is there a reset button on the pump? i also

I have a Jacuzzi Cirrus, bought in 1996. It leaks slowly (I have to fill every 2-3 days. It drops about 8 inches and gets close to below skimmer. Do you know what could be leaking? Each of the jets ...

Jetted bath tub has stopped working. Motor hums Jetted bath tub has stopped working. Motor hums but no water comes out. Bathtub filled with water 2inches above jets. Any help would be appreciated. ...

Why does my hot tub keep making noise a problem with the Heat Pump Alissa, could be a few this making noise from a loose bracket to a bad pump. You may want a good tech. to have a look , diagnose and ...

...pump and cause it to fail. check the jet faces when you turn the pump on. also a dirty filter will cause low water flow so check that too. take it out and see what pressure you get through the

...an air blower with a ceramic heater on the intake. Avoid using the venturi style air controls. As heating and filtration are done on the pumps low speed you could change the control box to a high ...