Dremel Mini - Mite Cordless Rotary Tool "loosen collet" Questions

loosen the collet. Slow and steady should get it loose. Another option is use some penetrating oil sprayed lightly onto the back of the collet to help loosen it from the shaft etc. Same thing happened

...pattern. Turn counter clockwise to loosen the collet. Some time the collet gets tightened to toght and then just take a block of wood and gently hit the collet to see if this will loosen the

...loosen the collet to remove it. I tried pressing down on the red button and loosening the collet by hand (as the directions said), but still cannot loosen it. Can anybody help? Looking down on the ...

...on the collet nut and loosen the nut. If the bit is stuck just tap the end of it slightly to loosen it and it should come out. Reverse this process to install a new bit...hope this helps ...

...loosen the collet. I finally managed to get it off: but to prevent a repeated scenerio, do I need new parts or just maintenance? it is possible that you stripped lock mechanism on the collet, for the ...

...suppose to be a tool free bit insertion and removal. However a wrench may be necessary. If you have loosened the the collet nut either with the collet grip or a wrench and the bit does not come out. ...

...been used in a long time and I'm trying to change the bit/head. Even with the Collet nut loosened, the bit that's in there will not budge. I even took the Collet nut right off to make ...

...loosen the collet... Can I buy those 2 pieces? call dremel and ask for the part need you model number so have it ready Dremel Service CenterDremel Authorized Service 4915 21st Street4631 E. Sunny ...

...loosen the collet on my stylus ion. I only used it about 3 times. I read not to try and lock the tool while it's running. I never did this but wonder if my son may have by mistake. Would that cause ...

collet to loosen the bit then change bit tighten up and you are away lol hope this helps regards Jim I have this tool. First, lock the shaft with the shaft lock on the end of the tool (pull back on it