Canon MP610 Photo All-In-One Printer "paper pulls crooked" Questions

...crooked The paper is not being pulled into the printer straight. There are small sliders that rest next to the paper in the loading tray, you are required to push these so that they slide over and ...

Crooked Cpoies When I put a paper in to copy in my canon MF6500 copier the copy comes out but its crooked. (not aligned) Pull all of the paper out of paper tray and reload. More than likely you will ...

...paper to get crooked. It can also be caused by improperly adjusted paper guide or the paper is not in good condition. Paper Feed Rollers Are Rolling But the Paper Is Not Feeding How the Accu-feed ...

PAPER IS BEING PULLED CROOKED INTO THE PRINTER Make sure something hasnt fallen into the printer like a paper clip or something. I had that happen and was experiencing the same problem. Something very

crooked copies Faxes and copies are printing crooked. Tighten the fences and guides that hold the paper in place. If the paper is not snug in the tray, it will not pull through straight.

...crooked (paper must be feeding unevenly). You need to change the pick up rollers for your printer if it pulling the paper unevenly... but first check to see that the paper size adjuster on the tray i ...

...crooked? The paper is pulled in crooked and it then jams and Ihave to clear it from the back. how are the rubber rollers spposed to relate to the plastic tabs at the back. should they be in line with ...

...pulls the paper in crooked and it jams One of the biggest reasons for the paper feeding in crooked is that the platen (what the actual paper feeds across to be typed on) gets really slick. All in all ...

crooked and not aligned properly i had a paper jam before this and pulled it out-could i've broke someting or can i make it registerproperly any other way? thanks From HP's site: Problem: The print on

...paper feeds crooked. The left side pulls in but the right side of the paper feeds slower (or not at all, I'm not sure) This is a new printer that worked right for about a month. Defective rollers or ...