how do you attach "multipurpose cutting kit model 565" to the dremel multipro model 395? Remove the collet nut and collet then unscrew the sealing cap (black plastic ring), this has the same thread as
...395 has the solid base of the collet stuck inside the threaded bit. I discovered this when I bought new collets to replace the broken one. How to I remove the piece? The new collets will not seat low ...
Question about Dremel Tools & Hardware - Others
I can't get the head to open to take out the bit how do i open the head od the dremel model 395 i'm stumped Unplug it, then while pushing in the little silver button near the head use a wrench on the ...
Question about Dremel Tools & Hardware - Others
Dremel 395 in the middle of drilling sea glass and the collet and bit stop turning while the motor is still running fine! GRRRRR Thanks for any suggestions! sounds like the rubber connector between ...
Motor runs, collet doesn't turn I need the rubber sleeve that connects the motor drive end to the collet drive end. It disintegrated. Rest of tool works just fine. Where can I get one? get a hot glue ...
Question about Dremel Tools & Hardware - Others
Craftsman rotary tool doesn't lock down on the bits. I have used this tool for years, but when I took it out to use it this weekend, I couldn't get the collet nut to lock down on the bit. The shaft of
Dremel Moto-tool model 395 type 1 lock I am in need of a replacement collet lock spring ( includes lock and spring) You can either go to Dremel.com and type in your model number for replacement parts ...
Question about Dremel Tools & Hardware - Others
I cannot loosen the collet on my stylus ion. I only used it about 3 times. I read not to try and lock the tool while it's running. I never did this but wonder if my son may have by mistake. Would that
Question about Dremel Tools & Hardware - Others
My Dremel lock nut won't budge. My collet is stuck! How can I loosen the bit? You'll need to use either the built in shaft lock to hold the collet in a fixed position, or use a pair of slip joint ...
Question about Dremel Tools & Hardware - Others
Broken Dremmel tool spindle stop turning but motor runs My dremmel tool is an older model 395 type 3 about 20 years old but rarely used. I was using it to drill a pin hole in a gourd and all of a ...
197 questions posted
Usually answered in minutes!
35 Questions
27 Questions
32 Questions
23 Questions