Western Digital Caviar WD1600 (1600YD) 160 GB Hard Drive "pin settings slave" Questions

pins to the "Slave" setting, and on Western Digital drives it is one set of vertical pins going away from the 4 pin power input, the above picture is set for Slave mode, and can be used as a reference

settings are for Master/Primary and Slave. You want to set it up as a Slave. Sometime the connection ribbon from *********** board will have master/slave written on them. These also need to be correct

how do you turn a hard drive from master to slave Hi, To set a IDE Hard Drive as Slave you would need to change the jumpers/pins on the back of the drive See this link Here

...as the secondary drive on the cable with two IDE devices, move the jumper shunt on the drive to pins 3 and 4. If necessary, configure the jumper on the other IDE device as

...settings for a given hard drive mode. Follow the diagram and set the pin cap in its slave position on the hard drive--for example, some drives may require the cap to be placed on the last two pins to ...

pin set to primary and the secondary set to slave, if you're running both of these drives off of the same ribbon cable. You may have to go into your BIOS settings and check to make sure the Primary HD

...pin settings for slave mode second over from left shoud Be and S on it. Look at the outside carefully. A drives have little pictures or something that tells what pins are for what. But if not, then ...

...Slave drive. If there is a drive on the second ATA cable you need to determine the jumper setting of that drive and then set the jumper on the second hard drive to a different setting. BOTH drives on ...

...reset BIOS settings to reflect this) or just leave it in there as 2nd BIG HDD with lots of space. Good luck Find yours for the 160gb here: ...

...pin as detailed on the diagram. Connect the hard drive to the power and IDE/SATA cable. Ensure the other ends are connected to the motherboard. Use the screws to mount the drive. Replace the desktop ...