Hotpoint NVL333EY Electric Dryer "start switch working" Questions

...start switch (with ohmmeter) and it appears to be working normally. No frayed wires or shorts that I can visually identify. HELP! "Tested start switch and it appears to be working normally". You need ...

start switch and twist the timer and sometimes it would start - We noticed that the drum does heat up if you hold the start down for a while, so the burner is working - We get same result when ''Timed

...start switch just went out My dryer worked fine twenty minutes ago, now nothing. I can here the timer work but switch won't start dryer. Tried resetting circuit breaker and everything. Either your ...

...start switch has to be continually pressed to get my dryer to work If I bridge the Start switch the dryer works, so I bought a new Start switch but this is no different, is there another fault or is ...

...start, it may be because the door switch is either not working, or the mechanism on the door that pushes on the switch is broken off. There may be a small metal or plastic tip that protrudes into a ...

...start switch.whats suppose to happen is the power passes thru the push to start switch for a moment till the motor centrifugal switch goes to the run winding.what i have found happening is a lint ...

Start switch starts dryer but as soon as release d the dryer stops. Ifstart switch held in start position it turns and heats. one of 2 things, your door switch is not working or the wires are shorted ...

...motor but will not start !! Crossed out door safty switch and push start button and still nothing Bad motor relay switch, you will need to replace the motor and everything will work great after

...start, I carefully pressed the motor switch and the drum started spinning. I'll clean the switch out and put everything back together. For those reading, the switch is white with a black plunger on ...

...start switch is engaged but stops immediately on release of switch - I.E. must hold switch on for dryer to operate The motor switch is not working properly. You can try removing lint from motor area ...