...diagnostic mode"? y/n [n]: enable "use net in IP bcast address"? y/n [n]: enable "load rom after netboot fails"? y/n [n]: enable "use all zero broadcast"? y/n [n]: disable "break/abort has effect"? ...
Question about Linksys Computers & Internet
...diagnostic mode during every boot-up, this LED will flash. When the diagnostic is complete, the LED will be solidly lit.DMZ (Green) The DMZ LED indicates when the DMZ function is being used. This LED ...
...mode during every boot-up, this LED will flash. When the diagnostic is complete, the LED will be solidly lit. DMZ (Green) The DMZ LED indicates when the DMZ function is being used. This LED will ...
...Diagnostic Console of 2Wire, which is essentially the advanced configuration page, use the browser to go to ?http://gateway.2wire.net/mdc? or ?http://homeportal/mdc? (without quotes) instead. If ...
Question about Blitzz Technology Computers & Internet
...enable the network connection on my computer manually. Then I can connect to the internet and all works fine, until I shut the computer off. Hughes Net did diagnostics on the modem and it is ...
Question about 2wire Computers & Internet
...mode (deselect enable routing). You might be able to set the two routers to connect then from here: http://192.168.1.254/xslt?PAGE=J09&THISPAGE=J30&NEXTPAGE=J09 or somewhere else in the MDC, not sure ...
...mode to VCmux and switched to ppoa.there was a pop up at the end of the set up wizard which advised `unable to connect to configuration server` but it appears to have worked as i can connect to the ...
Question about Linksys Computers & Internet
...diagnostic check for the connection it says "there may be a problem with your dns configuration" then it says that the problem cannot be fixed automatically, the router is connected to a motum and a ...
4,210 questions posted
Usually answered in minutes!
1,852 Questions
952 Questions
689 Questions
416 Questions
299 Questions