Nordic Track NordicTrack A2350 Pro Treadmill "motor stops" Questions

...stops. Checked the motor brush it is fine and tried switching the power cables on the controller board, motor runs to high speed with direct current (which means motor is fine), it simply starts and ...

...the incline button, accidently pulled the key out and it stopped in the incline position making a motor running noise but cannot stop it and it won't change or stop that noise. Can stop by ...

Front Load wcvh6260 GE front load washer. Motor will not run. Found that no voltage was going to the motor or inverter from board. I replaced the board. Everything started to run fine including motor.

my incline motor stopped working on Nordic tracap apex5100 How do I replace incline motor? The incline motor stopped working- have new motor but need instructions. thanks! unplug unit and remove the ...

...motor turns slowly about 1 1/2 revolutions, stops, chugs another 1/2 turns, then a soft click in control board and stops see the video and lube, lube too the rollers bearing front+back too 2)see my ...

the belt skips when walking or running Take the motor hood off and set aside. Straddle the walk belt and set the speed to 3 or 4. Take one foot and step on the walkbelt hard. While doing this look at ...

...stops almost immediately after starting a slow walk. It does seem run well with no one on it. I have seen several online sources indicating that I should use a silicone spray on the belt, but the ...

...stop is a suddenly stop A treadmill will shut down from to much friction which is due to high motor current because the walkbelt and deck are not properly lubricated. I would recommend

...stops but has power While running the treadmill will stop. It will need to be unplugged and rep lugged to start again. Power board next to motor shows power. Any suggestions? the motor could be going ...