Jura Capresso Impressa E8 Espresso/Coffee Maker "machine drawer pulls" Questions

machine will not work Instructions from Capresso: -pull out the drawer -look inside the unit where the drawer has been removed and look for a flap (it's really the first thing you see on the left side

...machine. The drawer area gets a lot of residue from ground coffee. I have found that keeping this area cleaner than it will on its own can often times reset and even prevent this lever from falling ...

...drawer to not go in place. I have the same machine and this seems to happen if the grounds bin is pulled out before it goes through a full cycle. take both the grounds and water trays out. Try to fit ...

...machine on and wait until it stops making any noise. Now try to pull out the drawer. If this does not work, try the procedure again. If this does not work, call customer service Regards Kat (please ...

...machine , put some descale directly into the tank, heat up ( de scale works better at high temp) select rinse, clean or flush programme. the vast majorty of probs. are due to limescale in the narrow ...

...machine for one day. The next day, take out the tray and clear out all coffeegrounds inside the brewunit. Use your fingers and maybe a small towel. You can do this right away, but it is easier when ...

...machine. i have a Jura but not your model - try pulling out the drawer and container that collects the used ground coffee and with a damp cloth put your hand up in the machine to the shute and wipe ...

...drawer to empty the grounds. Can get the tray in, but if I put in the grounds holder, the tray won't go in. It is hitting something in the back of the machine Place the tray into the coffee maker ...

Jura Capresso E8 keeps getting error code 8 over and over. I will clean, remove grounds etc, it will make a few espressos, then back to the error code. I can hear it struggling. One of the problems ...

machine that I had to call support for the same problem. An easy fix! I was instructed to remove the whole 'drawer assembly' and remove the grounds bucket. Insert the assembly without the bucket. Wait