SOURCE: Hydraulic clutch problems
i have a ktm 125 wich all ktms have hydraulic cluthcs and i have the same problem as all these fellas even when im riding it just sucks right down all the fluid reply to me on [email protected] ok thanks fellas
SOURCE: Bleeding clutch slave cylinder
i think youre doing the right thing. they are very stubborn to bleed because the hyd. line goes up high across back of engine before droppiing back down to slave cyl., trapping air. could try to gravity bleed by opening bleeder at slave, cap off of master cyl, full with fluid then it may start to come out after a bit. then try your process again. or can try to bleed at connections further up the line, working your way back to bleeder. hope this helps. be patient.
SOURCE: I installeda new clutch master
you need to back bleed the system.
snapon and parts stores sell a bleeder but for many year i have use just a simple pump oil can and a hose to connect to your bleeder fill your oil can with brake fluid and with the cover off you master. now just pump fluid up therw your master .
SOURCE: Bleeding Clutch Cylinder with no bleeder screw
I have not tried myself but see if the link below will work for your case. It is not the same model as you have but most vehicles have the same components for the non electronic parts. http://www.2carpros.com/forum/1988-dodge-dakota--bleding-air-out-of-clutch-master-cylinder-vt248517.html
SOURCE: 1999 pontiac sunfire bleeding clutch
my 1999 pontiac sunfire drivers door latch is broke can not close the door. i have it pulled shut? how much will a used latch cost, or even 3 bolts for it? all the auto stores/ jumk yards are closed for me to call
256 views
Usually answered in minutes!
×