Welcome to FIxYa.com Regards, Lee Davidian Thank you for using FixYa.com
It is located along side the fuel vapor control Carbon canister in a tray near the gas tank in a tray under the car, u will see hoses going to it
oops got this wrong, here is the location
purge valve is located on the back of the intake plenum, if you follow the vacuum line you will come to the valve mounted in a rubber sleeve. If the canister that is mounted under the left rear corner of the car has failed the carbon contained there will be drawn by vacuum to the front and get stuck in the valve. Inspect the valve for this carbon contamination.
see picture of valve and valve location below
1. is the valve
2. is the location in the illustration marked #16 at back of intake manifold plenum rear of engine.
3. is the carbon canister at rear of car.
the picture of the purge location is the same as mine, thanks emission wiz, lee
×
SOURCE: where is the purge valve
Go to www.hmaservice.com and register your vehicle by VIN #.. you'll then have access to wiring diagrams, shop manuals, service bulletins, illustrations and procedures, etc.
EVAP System Incorrect Purge Flow (Stuck Open)
Possible Causes:
Charcoal canister is damaged, clogged or restricted.Purge solenoid control circuit open, shorted to ground or power.Purge solenoid power circuit is open (check the relay or fuse).Purge valve vacuum line is clogged or contains water or debris.Fuel filler cap loose, cross-threaded, incorrect part or damaged.Fuel tank or fuel tank sender assembly 'O' ring is leaking.Fuel tank vapor line(s) blocked, damaged or disconnected.PCM has failed.Here are the causes.
3,169 views
Usually answered in minutes!
×