Questions & Answers for: intake plenum

...intake plenum. There is really no other way to do it. It is not a hard job, removing the intake plenum, but, trying to tackle the rear cover without taking off the plenum is almost impossible. If he ...

...Plenum and the lower intake dries up and gets sucked into the intake a little causing a leak and a high idle issue. The repair requires the removal of the plenum and replacement of the gasket. NOTE: ...

...intake plenum off a 02 freelander I have all the sensors,vacuum lines off etc..... all bolts that I see, its definately loose but not coming off. My 2002 Land Rover Freelander V6 thermostat crapped ...

ANTI-FREEZE LEAK AT INTAKE/PLENUM MANIFOLD. ANTI-FREEZE LEAK AT ENGINE INTAKE/PLENUM MANIFOLD. Not alot you can do but remove the intake plenum and have the gasket replaced.

...manifold, modern fuel injected cars and trucks (gas engiones) have a upper and lower intake manifold, the upper section is called the plenum. It is the upper intake that looks like aluminum pipes

intake plenum assembly. On some vehicles this sensor is combined with the MAP/MAF sensor. 3.- The IAT sensor is located in the air plenum assembly. On some vehicles it is combined with the MAF sensor.

intake plenum leak antifreeze into the Can a bad intake plenum leak antifreeze into the engine on a 2002 century 3.1?The computer code was misfire #1 cylinder. Complete tune-up done, same problem, new

...intake plenum bolts removed( 4 small in the rear and 4 large in the front)as specified in RAVE. intake plenum seems to be stuck. it moves back and forth a little, but when i attempt to apply upward ...

so that I know what I am looking for. they will be on the passenger side of the engine mounted to the lower intake just under the intake plenum. This pictures shows them with the intake plenum removed

...intake plenum will need to be removed. Not to hard to do. make sure you replace the gaskets before reinstalling the plenum. Also not a bad time to replace the spark plugs as long as you have the ...