20 Most Recent Hyundai Motor 2002 Elantra Questions & Answers

mine is in my owners manual

Make sure the 3 prongs (2 silver & 1 gold) line up to connect properly when you put it back in. I had to pullout the gold outside of where the bulb sits and slightly pull out the 3 in the actual lens to get a good connection. ***This is what makes the turn signal wireless... They have to be aligned and have contact****

I would say no,has to come apart

remove the interior door trim and you will see small nuts holding the handle onto the outer door skin. Remove any rods /clips and undo the nuts and the handle will come out.

The best solution you'll get from books at www.reliable-store.com These are books containing info on repair, service, troubleshooting, parts info, assembling dissemble, removal, error/fault codes, wiring diagrams and everything on any vehicles cars, atv, trucks. forklifts, boats, excavators etc

need new head light switch

Faulty brake switch.

Normally the Audio (Radio CODE) is noted in the owner's manual. If you don't have it, you must contact Hyundai Motor America and give them the Vehicle VIN number... they may then (possibly) be able to give you the CODE.

hyundai elantra If you want to solve your problem, click on the link I attached

If the test says it the issue.. you have no choice but to replace it.. (you could cut it apart and clean it out, then reweld it)..BUT if the inspectors see it,, you are IN BIG TROUBLE!!

you have to mention the make and model that is being tested there are codes but if it is a GM product many scan tools will not read the faults because it requires a scan tool with a special protocol for GM if it is a nissan , the ECM has a small screw that has to be turned to get the codes to read The car is playing so rest assured there are fault codes but who ever is doing the reading is using the wrong scanner or is not familiar with your make of car requirements

Sounds like the fuel pump is starting to go, the problem after fill up is most always related to a failing pump. The other issue may be a dirty throttle valve.

This issue is often caused by the PCV circuit. Check the PCV valve and port for clogging or torn/leaking hoses.

You don't say if you had it checked for DTC's - diagnostic trouble codes ? Have a scan tool that views sensor data hooked up . See what the PCM/ECM or TCM is see for input data . Your best bet mite be to take to a qualified repair shop that has the diagnostic equipment an knowledge to find the problem . Rather then guessing an just replacing parts .

repair manuals have wiring diagrams 1996 2013 Hyundai Elantra Haynes Repair Manual PDF