Question about 2000 FLSTC Heritage Softail Classic
...carb lines , 1 has a one way valve and the other is an open line. Where do they connect to the carb ,is the one way line connected to the topof the carb or below by the carb bowl? and which way does ...
Question about 1996 Royal Star XVZ 1300 A
...carb did't find any problems reinstalled carbs and still have problem I think poss. valve stem seal compression on # 3 240 psi What is the compression on the cylinder compared to the other cylinders? ...
Question about 1996 Royal Star XVZ 1300 A
...carb cleaner used, and the exact type of needle valve in your carbs, the needle valves may have been dammaged during the cleaning. Some carb cleaners can "eat" neoprene or rubber components in carbs. ...
...valve in the carb bowl. You will have to take the bottom of the carb off to do this. Remove the float bowl, then carefully remove the float. The needle valve is attached by a small wire catch to the ...
Question about ACDelco 3,500 Watt 6.5 HP OHV Portable Generator, CARB Approved #AC-G0002
...carb? (Float valve 'sunk' or corroded or valve seat faulty) I suspect it is the carb you are talking about. Either rebuild or have your carb rebuilt and that should take care of the problem. Thanks ...
Question about ACDelco 3,500 Watt 6.5 HP OHV Portable Generator, CARB Approved #AC-G0002
valve on the carb. I recommend taking the carb off, taking it apart and cleaning everything well with carb cleaner. When you remove the lower bulb on the carb there will be a float valve inside. Check
Question about Polaris ATV
...330 it run great juste for iddle i dont push the throtle beacause de motor spark with fire in the carbs but on iddle motor run great ????? cdi or carbs This could also be valve lash adjustment or ...
...carb slowly turn valve on to see if you have fuel to the carb if there is fuel there turn valve off install hose back on carb remove remove hose at tank valve now on the bottom of the carb you will ...
Question about 2007 Grizzly 350 Auto 4x4
valve then the carb has to come off and you need to recheck the needle valve. The needle valve is what the float pushes against when the fuel level is correct. It is easy to damage by placing pressure
Question about 2007 Grizzly 350 Auto 4x4
...needs adjusting or the valve may be leaking. Either way the compression is blowing past the inlet valve seat and out the carb, and the gas with it. Inlet valve should have ara minimum. 004"
Usually answered in minutes!
652 Questions
681 Questions
595 Questions
586 Questions
644 Questions