I have to jiggle the ket to star the fan blower or

Try putting the key in the door locks and holding it all the way to the right and they should go up. If not try turning the ket all the way to the left. Hope that helps

UIf you have automatic tempertaure control, skip the auto parts store call Ford parts and ask for blower contorl module Could possibly be a stuck heater blowe relay. Might try jiggling the ket in the ignition and messing around with that a bit...if it stops then there is a shirt in the wiring harness where it ties into ignition.accesory funciton of the car

Jiggling the key would tell me the ignition lock switch is worn out.

dont know if you recd my previous so again...unlock/hold over windows go down,lock/hold over windows go up/sunroof closes.(alarm/immobiliser resets)....key stuck in lock, pull hard when upright,moving the key up/down when pulling, should do it.also bootlid lock two positions,turn left,then release or turn right and release,see what happens......(boot isolation from the central locking)

mine did the same thing - there is a wire harness on the passenger side that passengers kick with there feet - this can be jiggled and the fan wil start working on all speeds in my truck - hope your fix is as simple

It is the aspirator fan motor. It samples the cabin air to help control the a/c & heater functions. It should cut off within 30 minutes BUT, if you open the door it starts again so roll the window down so you can hear without opening the door. Reach under dash, pull aspirator straight down, clean it and blow air thru the vent it attaches to, push it back into its hole and hopeully it will run quiter for you. Good Luck, ChocolateFreak.com

it looks like the starter is bad, install a new one. the antenna gear is broken, needs to be replaced and you need to check the rear hatch for any obstructions

Have you tried pushing the gear shift or jiggle it towards park, it may not be all the way in park.

I just needed to jiggle the steering wheel back and forth while turning the key.

Try changing your ignition switch or checking the wiring to it.