Trouble Code: P0410 (4.2L L6 VIN S Auto)
HO2S 1 Insufficient Response
Print this code data
Number of Trips to Set Code: 1
OBD II Monitor Type: CCM Details
Indicators: MIL Details
Trouble Code Conditions:
-
DTCs P0105, P0107, P0108, P0112, P0113, P0122, P0123, P0130, P0131, P0132, P0133, P0134, P0171, P0172, P0300, P0301-P0304, P0341, P0506, P0507, P0601, P0602 are not set.
-
The AIR system is commanded ON for more than 20 seconds.
-
The IAT is between 1-151°C (32-302°F).
-
The engine coolant temperature (ECT) is between 5-114°C (41-230°F).
-
The start up ECT is between 3-50°C (37-122°F).
-
The battery voltage is more than 11 volts.
-
The engine run time is more than 200 seconds.
-
The vehicle is operating in fuel trim cells 16 or 17.
-
The throttle position (TP) change is less than 5 percent.
-
The manifold absolute pressure (MAP) is less than 30 kPa.
-
The engine speed is more than 1,150 RPM.
Possible Causes:
-
An intermittent may be caused by any of the following conditions:
-
Low system airflow
-
Excessive exhaust system back-pressure
-
Pinched, restricted, split, or damaged pipes/hoses
-
Restrictions in the AIR pump inlet hose
-
Pitted contacts in the AIR pump relay, AIR solenoid relay--Tap on the AIR pump relay or AIR solenoid relay to attempt to duplicate an intermittent condition.
-
Heat damage to the AIR outlet hose may indicate an shut-off valve failure
-
Yellow tinted water in the AIR pump may indicate an shut-off valve failure
-
Water or debris ingested into the AIR pump
-
Observe the Freeze Frame/Failure Records to aid in conditions of setting DTC P0410
×