2002 GMC Envoy Logo

Related Topics:

Travis Clark Posted on Mar 04, 2018
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

Where is the mass air flow sencer location on 02 envoy slt

1 Answer

Ryan Lutton

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • GMC Master 1,267 Answers
  • Posted on Mar 05, 2018
Ryan Lutton
GMC Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Nov 17, 2010
Answers
1267
Questions
4
Helped
594108
Points
3608

02 I6 doesn't have one. I believe 06+ have them, but not the older ones. My 06 does have one, located right after the throttle body towards the air box.

5 Related Answers

Anonymous

  • 566 Answers
  • Posted on Dec 20, 2008

SOURCE: Where is the mass air flow sensor located on a jaguar x-type

hi from the uk the location of mass air flow sensor on x type jag is as follows==it is on the r/h/side of the air filter cover with jaguar embossed on top? this sensor is just prior to the intake hose that connects to the motorised throttle body from filter connections underneath it to unplug and meter is held by two screws ?if memory serves ? may i suggest you remove the large hose and use a little wd40 or similar to clean /lubricate the throttle butterfly in throttle body throat at this point so as to prevent future sticking upsetting of idling ? hope this helps ?

Ad

Anonymous

  • 1990 Answers
  • Posted on Jan 23, 2009

SOURCE: 2003 gmc yukon wont idle

I know that this will sound Stupid. Change the Fuel Cap. If the Seal on the Gas Cap is Bad it will allow Air to get into the Fuel tank and cause your Rough Idle.

Anonymous

  • 5081 Answers
  • Posted on Aug 03, 2009

SOURCE: Mass Air Flow problem

The M.A.S. is in the top of the metal tube between the air filter box and the intake manifold. It will have a wire connected to it and it is held in by 2 screws. This is an easy replacement and should take no more than 5 to 10 minutes, assuming you are taking your time.

Anonymous

  • 15935 Answers
  • Posted on Sep 04, 2009

SOURCE: location of mass air flow sensor

The sensor is mounted on the throttle body between the air cleaner assembly and the air cleaner outlet tube.

4641370.jpg
Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question.

Anonymous

  • 1986 Answers
  • Posted on Sep 15, 2009

SOURCE: where is 02 sencer heater (bank 1 sencer 2)

I believe your car only has a single catalytic converter. If that's the case, then your bank 1 sensor 2 will be the O2 sensor that's located after the Catalytic converter away from the engine

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Is the transmission fluid located on an 02 Envoy SLT

I assume you mean the transmission oil dipstick - under the hood near the firewall beside the heater box. The motor oil dipstick is nearby.
0helpful
1answer

Where is mass air flow sensor located on 2005 gmc envoy?

looking at the engine to the left /passenger side front will see the air filter housing and a large black tube the m.a.f. is mounted inline with the tube next to the air filter box
How To Install Repalce MAF Mass Air Flow Sensor v8 5 3L GMC Envoy and XL...
0helpful
1answer

A/c not blowing on front vents only.

I believe, on the Envoy, there are three small motors that run the Vent doors that direct the air flow. Obviously one is not working properly
0helpful
1answer

Ok, i have a 2000 sierra 5.3 slt got the p0101 code it wouldnt star up unles i give it some gas and it shots off so, rough idle and wont stay on, i change the MAF sensor (new delphi) but still doing the...

The Mass Air Flow (MAF) sensor is located in the stream of intake air and measures this intake flow rate by measuring a part of the entire intake flow. It is what they call a hot film and is supplied with electric current from the Engine Control Module (ECM).
The temperature of the hot film is controlled by the ECM to a certain extent. The heat generated by the hot film is reduced as the intake air flows around it. The more air, the greater the heat loss. Therefore, the ECM must supply more electric current to maintain the temperature of the hot film as air flow increases. The ECM detects the air flow by means of this current change.
The OBDII people suggest that before you replace the mass air flow sensor, try replacing the air filter and cleaning the air flow sensor with compressed air or by using a cleaner on the mass air flow sensor. Truly, all that may be wrong is a build-up of dirt.Unfortunately, in your case, replacing the Mass Air Flow did not work.After replacement, did you reset the code and drive the vehicle?.
I suggest you replace the air filter and check for intake air leaks.YouTube has some good videos on how to do this, one by Eric the car guy and one by Scottie Kilmer https://www.youtube.com/watch?v=9CPqbaSgcokhttps://www.youtube.com/watch?v=zMok2y05jNE
0helpful
1answer

Mass air flow sencer

this is located between the air flow meter and the inlet throttle body and measures the air intake of the engine in order to match it with the correct fuelling
0helpful
1answer

How to replace a maf sencer for my 2006 Kia optima

mass air flow usally located near air filterto the throttle bodyit will have wires coming out of it
0helpful
1answer

Try to find a mass air flow meter for a trans am 02

I think what you might mean is....a MAF or a MAP...Mass air flow sensor, and a Manifold absolute pressure sensor. MAFM may refer to a Mass air flow meter....PHB
0helpful
1answer
2helpful
1answer

Can't locate Intake Air Temperature Sensor Connector

The IAT is integrated with the MAF (Mass Air Flow) sensor all one unit the following diagram should help
9b5bca8.jpg
Not finding what you are looking for?

639 views

Ask a Question

Usually answered in minutes!

Top GMC Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...