SOURCE: Need torque spec for 2000 Cirrus outer tie rod ends
45 Ft-lbs Tie-rod balljoint stud-to-steering knuckle nut, and 55 Ft-lbs Tie-rod (outer)- to- inner jam lock nut
SOURCE: torque specs. for outer tie rod ends for 2006
Tie rod end is 35 ft. lbs. Pinch bolt for the lower ball joint - 105 .I hope this helps you
Testimonial: "thanks for the help"
SOURCE: 2000 LINCOLN LS - Outer tie rod removal assistance
Yes degreaser will not hurt it. The outer tie rod is retained only by one nut that connects it to the inner tie rod.Once you have this loosen just turn the outer tie rod to the left to remove it from the inner tie rod.
SOURCE: 2005 malibu maxx ball joint and lower control arm torque specs
A Ball Joint Can Usually Be Replaced Without Removing The Control Arm From The Vehicle. Place The Vehicle On Jack Stands. Remove The Shock Absorber And Install A Spring Compressor on The Coil Spring.Remove The Nut Securing The Ball Joint To The steering Knuckle And Separate The Knuckle And Then Joint. The Ball Joint Should Be Pressed,Riveted,Bolted,Or Screwed Into The Control Arm.A Service Manual Will Give The Details For The Specific Make And Model Vehicle.
2,089 views
Usually answered in minutes!
×