20 Most Recent 1994 Buick LeSabre Questions & Answers

never none a gm product to have a inertia switch only ford uses them if you suspect fuel is problem have someone smack the bottom of fuel tank with hammer while you try to start car if pump is bad it should start but may not

Could it be coming from the dash??? That car might be old enough to have a speedo cable. Another thought, I know some Caddys that had an automatic park brake release. You had to put it in gear for the Park brake to release. Hope that helps.

try looking on google search ,I found that looking for things in the " images" section of google lots of things pop up,good luck,Gary

If it is a 3.8 engine change the crank sensor,they go bad on the 3.8 engines.

Bad battery, starter, starter relay. Anyone of those could be it. If it clicks and the battery is good than usually the starter is bad. If you know the battery is good take out the starter and have it tested. If it is bad than replace it. Local parts store can test starter. If starter is good than swap a good relay with the starter relay and try again.

The chance of the Power Train Control Module (PCM) failing is very small, about 3% per industry research, so expert ndguy2481 is giving bad advice, it is more likely the crankshaft position sensor or the ignition module have a problem when they warm up. Run a test on the PCM to retrieve the trouble codes, I know there will be some. The connector to do this test is under the dash below the steering wheel under the dash panel.

go to parts.com, enter your vehicles info, and it will show your a detailed breakdown of the latch assembly

if a 17 mm bolt head then around 90 lbs if 19mm then 120lbs

Will it hurt the vehicle from it's everyday driving

On this website you find fuse box diagram and description for Buick LeSabre (1994) Buick LeSabre 1994 fuse box diagram CARKNOWLEDGE

Sounds like you a loose 12V connection at the relay box.Locate the relay box and when the engine is running wriggle the wiring harness or shake the relay bow and see if that's when the engine stalls. You may even have a bad / loose ground to the relays.

At this website www.reliable-store.com I found all complete guide,much better language, complete detail in 800+ pages, ..and they also have live chat for instant help feature

check the catalytic converter for being clogged you do not always get a trouble code for a clogged cat

Your best bet ,take it to a qualified repair shop that has the proper knowledge an testing equipment . 003 Fuel System Tests Scan Data Tests 003 Engine Peformance Tests Scan Data Tests

http://www.autogenius.info/buick-lesabre-1994-fuse-box-diagram/

no the crank shaft sensor would not stop it from turning over

Classic signs of coolant in the oil and since heads were repaired and sealed, it could be a cracked block. Coolant is mixed in oil and coolant impedes lubrication of engine thus hard to turn over and start. One last hope is to drain crank case, refill with fresh oil and new filter. Add Barr's leak "copper" )(looks like liquid copper and costs about $10) sealant to coolant fluid. Run the engine a few times to full warm up, each time observing for tell-tale white smoke from exhaust. Check dipstick level between each cycle. If problem subsides, go buy a lottery ticket as you're very lucky. If not, a new engine or short block is on the menu. Good Luck

The ECM may be dead .

Check the actuator motor and rods on the heater box inside. The motor moves the doors in the heater to direct the heat to the area you request. It is a small motor on the driver side or in front of the heater above the dash.