Door wont open with inside release handle
SOURCE: Door Panel removal
remove all visable screws from panel and arm rest. Arm rest should come off. Use a flat thin tool or piece of metal and slip it between the panel and the metal door frame. Slip it in about 2 inches,. Slide it back or forth til you hit a stop. That should be a plastic pop in.twist metal tool to pull panel away from the door. It should pop away from door frame. Don't overdo it if it doesn't come out. try another spot. once you get one loose, you can tell how to get the others out. Once panel is loose push it upwards to get top lip out of window bottom. If it has power windows,disconnect plug. If it has manual windows, you will have to remove the window crank There is a snap ring behind window crank that has to be removed.push in on panel by window crank and you can see the ring.
SOURCE: Broken inside door handle-1996 Chevy Silverado Extended Cab
On almost all GM's there will be a screw in the recess that the handle sits in. After removing this screw, gently wiggle this cup out of it's hole and there should be a metal rod attached to the back of it with a small clip. Unclip this and it's out - installation is the reverse. Just don't lose the clip or let the linkage rod fall down inside or you will have to remove the door panel. It shouldn't take five minutes to replace and most parts stores now carry GM door handle assemblies. Good Luck!
SOURCE: 2002 2500 Silverado tailgate handle will not release catches
You will need to remove the trim piece the is under the release handle. Be carefull those things tend to break the little tabs that hold them on. Anyway pop (pry) it off with a screwdriver. Once it is off you can see that the little clips that hold the rods to the handle assy are broke. These clips are color coded. Most likely yellow or green. You might be able to get them at say Pep Boys or some place like that but they might make you buy an assortment package , then you get clips you will never use. Good luck, hope this is helpfull.
SOURCE: Repalcement process on inner tie rods 05 silverado
undo bolts on inner and outer tie rods,u might need balljoint fork separator or 2 jaw puller to take them off of relay rod and steering knuckle,measure lenght of tie rod,loosen tube clamp and undo tie rod from tube,when installing make sure lenght is the same as before or wheel alignment will be off!
SOURCE: 2007 chevy tahoe driver side door handle will not open door
the linkage behind the handle either the retaining clip broke or popped off need to remove the door panel to check and fix
Testimonial: "Thanks I thought it might be a cable or linkage. Much thanks"
338 views
Usually answered in minutes!
×