Question about 2008 Volvo S40

1 Answer

A hole in the sump

How to fix a hole in the sump.

Posted by Anonymous on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Volvo Expert
  • 496 Answers

JB Weld Epoxy is what I normally use.

Posted on Jun 14, 2015

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What could be wrong with my Kubota 1720-oil is coming out Of the dip stick hole?


diesel engine - diesel fuel leaking from seals in the pump and getting into the sump oil
if petrol as on a mower , needle and seat defective allowing fuel to drain into the sump

Jun 30, 2018 | Cars & Trucks

1 Answer

If the car is a quart and a half low does Subaru have a shut-off feature to keep from hurting the engine.


No. The bigger issue is why is the oil level going down, assuming you do check the level, say, once a week. Oil leaks can be from
* the head gaskets on older 2.0 models.
* rust holes in the sump pan. Patch the holes with JBWeld or better, replace the sump pan.
* rear crank seal.

High oil consumption also occurs on older engines, say 180,000km or more, via worn valve seals. You'll usually see blue smoke blowing from the exhaust. The fix is recondition the heads, a major job.

Oct 27, 2016 | Subaru Cars & Trucks

1 Answer

I just performed a compression test on my PT Cruiser because when it died the Oil Pressure Lightindicating low pressure came on & has remained on & I was told to check the compression.


From what you are saying you have no compression on 2 cylinders . which means that the rings are broken or worn out or you have a head gasket blown on 2 pistons . . Head off sump off replace rings , Surface the head new head gasket , big work

May 02, 2016 | 2002 Chrysler PT Cruiser Limited

1 Answer

What to do when there no psi on cyl 4 to get the psi up agan"?"


There are at least three possible reasons for no psi in cyl No 4.
1. Burnt or damaged exhaust valve in that cylinder
FIX Remove head and replace faulty valve
2. Blown head gasket (water mixed with sump oil shows milky on dipstick and steam or water coming out of exhaust tailpipe, radiator water disappears )
FIX Remove head, grind flat and assemble with new gasket.
3. Broken piston rings, or cracked piston or burnt hole in piston.
FIX replace faulty parts.
Squirt some sump oil ( 2 or 3 spoonfuls ) through spark plug hole,
spin motor , and if compression PSI improves then it is rings or piston, if no PSI then it is faulty ex valve !!!

Jun 26, 2014 | 2003 Mitsubishi Lancer

1 Answer

Why does the oil in my 2001 2.2l chevy s-10 look milky like a blown headgasket but does not overheat?


milky sump oil is coolant liquid in the oil. The leak may not necessarily be a head gasket but a corrosion hole behind the water pump impellor that is allowing water through the timing cover and into the sump. At this stage it will be a pin hole but it will get bigger.. Fix the problem as the water in the oil destroys the oil capabilities and will lead to engine failure.

Nov 29, 2013 | 2001 Chevrolet S-10

1 Answer

How do I remove oil pan / sump?


AutoZone has free repair manuals online. I would guess you are just dealing with a sticking gasket. If it does need help you should find separate holes that are threaded on the pan.

May 04, 2013 | Hyundai Motor 2002 Elantra

2 Answers

I have a 92 Honda Accord, what causes oil around the spark plug. and how do I fix it. Would it also mke the vehicle run bad?


1. Worn or broken rings on that cylinder
2. Valve guides or seals worn on that cylinder
3. To fix the rings you will have to remove the head and sump (Remove the motor from the car if you cannot remove the sump with it in the car)
4. Yes it will make your car run bad

Jul 09, 2010 | 1992 Honda Accord

1 Answer

How to fit it. bull bar


the main fixing bolt holes are usually below the front bumper, at the sump guardand behind the front grille for the secondary holes

Jul 28, 2009 | 2002 Land Rover Range Rover

1 Answer

Oil leak in punto


The punto's suffer from porous sumps. The metal becomes thin and leaks oil. Although its not a difficult job to change, its a messy job. You have to draain all the oil out first, then remove all the bolts around the sump pan. If you are replacing the sump, its good practice to replace the gasket too.
The sump itself is not too expensive to purchase, and the job itself in a garage, shouldnt take any more than 2 hours.

TL

Dec 17, 2008 | 2006 Fiat 124

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volvo Experts

Marvin
Marvin

Level 3 Expert

84625 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...