20 Most Recent 2000 Volvo S40 Questions & Answers


Instructions

1 Make sure all doors are closed, as well as the hood. Make sure the tailgate or trunk is locked. Get into the car and lock all doors.

2 Insert the key and turn it from the insertion position (position I) to the "on" position (position II - not the "start" position) five times. In other words, all the dash lights come on, but the engine doesn't start. When you turn the key to ON the fifth time, leave it there. You have 10 seconds to perform this whole step.

3 Hold down each remote button for a second or two, so the car identifies those buttons as the ones to respond to. If you want multiple remotes to work for that car, you'll need to hit the buttons on each of them in rapid succession (all within 5 seconds) as well. You can program up to three remotes per car.

4 Get new batteries if the above doesn't work, and try it again. If you already have new batteries in the remote, then proceed to the next step.

5 Press and hold down the odometer reset button.

6 Turn the ignition switch to the RUN position.

7 Release the odometer button while the service reminder light (SRL) flashes. Don't wait until the flashing stops to release the odometer button. If you did that, you waited too long.

8 Turn the ignition off.

2000 Volvo S40 | Answered on Jan 14, 2019



Power Dr Mirrors Diagnosis & Testing


Removal & Installation
Motor
  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Remove or disconnect the following:

    Disconnect the negative battery cable. The mirror inside cover trim The door panel The electrical connector to mirror motor The nut attaching mirror assembly to door frame The outside rear view mirror

    0900c152801c11d4.jpg enlarge_icon.gifenlarge_tooltip.gif

    Fig. Removing cover trim and nut
    Removing cover trim and nut

    0900c152801c11d5.jpg enlarge_icon.gifenlarge_tooltip.gif

    Fig. Removing mirrored glass from assembly
    Removing mirrored glass from assembly

  3. Remove the mirror glass:
    1. Fold the mirror glass forwards and inwards as illustrated.
    2. Grasp and pull the mirror glass lengthways until it releases.
    3. Work the glass out.

  4. Remove electric motor:
    1. Remove the 3 screws from behind the mirrored glass.
    2. Separate the connectors
      NOTE Remember the positions of the connectors.
    3. Remove the mirror motor.

      0900c152801c11d6.jpg enlarge_icon.gifenlarge_tooltip.gif

      Fig. Removing connectors and screws holding mirror motor
      Removing connectors and screws holding mirror motor



To install:
  1. Install or connect the following:

    The electric motor The electrical connections The 3 screws that go behind the mirror Install the terminal pins Fold out the mirror mounting on the motor Hook the mirror glass into the inner mounting Press the mirror glass into place. Place mirror in position in door

    0900c152801c11d7.jpg enlarge_icon.gifenlarge_tooltip.gif

    Fig. Reattaching mirror and electric motor connectors
    Reattaching mirror and electric motor connectors

  2. Install or connect the following:

    The nut attaching mirror assembly to door frame The connector The door panel The mirror inside cover trim The negative battery cable

2000 Volvo S40 | Answered on Nov 26, 2018


Call your Volvo dealer with the VIN number. They can give you the code and advise if you can reset it yourself or if you will have to take it in.

2000 Volvo S40 | Answered on Sep 18, 2018


Motor mounts

2000 Volvo S40 | Answered on Feb 08, 2018


You most likely had air trapped in the cooling system after the heater core replacement .Its CRITICAL all air is bled out of the cooling system ,and when servicing the cooling system not only is it important to bleed out any and all air .You also need to make sure the cooling system is topped off correctly .Since i don't know the year ,and model Its hard to say why it wont start .Unfortunately when you over heat a car to the point it dies .Then i would be more worried about cracked and or blown head gaskets .All it takes is one time on many cars To overheat it to a point of stalling many times head gaskets crack ,even cylinder heads around the valves can crack .You would be very lucky if no damage resulted from overheating ,which in this case the worst thing to happen or do is keep driving it ESPECIALLY until it stalls You should have pulled over the second you knew it was getting hot and let it cool You may have caused more damage than you realize Like i said if nothing happened from overheating the car then your extremely lucky

2000 Volvo S40 | Answered on Jan 19, 2018


Still sounds like the turbo. Unless you got it from a reputable place I would go back and get another.

2000 Volvo S40 | Answered on Dec 18, 2017


EGR may be sticking open causing lean fuel issue .

2000 Volvo S40 | Answered on Oct 09, 2017


Normally pretty simple and easy. Don't know about Volvo-maybe some models need a lot of stuff removed to get to the assembly. Look on you tube video for headlight removal on Volvos-probably some or many.
That cost sounds outrageous-$260 for both headlights? I'm sure you could do it yourself, maybe just need a little guidance. Talk privately to a Volvo mechanic.

2000 Volvo S40 | Answered on Oct 02, 2017


Take it back. You have paid for a job that was not up to Volvo standard.

2000 Volvo S40 | Answered on Jun 22, 2017


it could be one of 2 things the cam sensor or the co sensor on the exhaust, both of these when warmed up will set off an eml light and confusing error codes. as when engine is stopped they reset themselves. but codes will be logged and they need to be warmed up again. cam sensor faults is when the resistance in the sensor become erratic. as it has volts on the sensor will go up and down. co sensor can be the heater as it has to heat the sensor to make the sensor reliable. it takes a few seconds for the sensor to read. if it fails and come up on eml light but then turn engine off and then start it again it can be this cam and crank sensors work the same way they can over heat them selfs of time and will both need replacing, i found its best to replace both at the same time.

2000 Volvo S40 | Answered on Jun 21, 2017


You will be looking for a sensor that sets the maximum movement of the arm

2000 Volvo S40 | Answered on Jun 08, 2017


My V70 did the same. Turned out to be the bonnet lock switch. Volvo said, drop the bonnet closed from six inches, (no more).

2000 Volvo S40 | Answered on Jun 06, 2017

Not finding what you are looking for?
2000 Volvo S40 Logo

1,028 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2001 Volvo S40
2001 Volvo S40

488 Questions

2005 Volvo S40
2005 Volvo S40

319 Questions

2006 Volvo S40
2006 Volvo S40

169 Questions

2004 Volvo S40
2004 Volvo S40

152 Questions

2002 Volvo S40
2002 Volvo S40

127 Questions

Top Volvo Experts

Marvin
Marvin

Level 3 Expert

84027 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22483 Answers

Jonah Oneal

Level 3 Expert

14065 Answers

Are you a Volvo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

S40 Volvo

  • S40 Volvo

Most Popular Question

2000 volvo start problem

  • Cars & Trucks
Loading...