SOURCE: 2006 mercury mariner. stupid tail light assembly.
they are hard to take off sometimes, you are doing it right just keep willing it it will come off, there is 2 gromits that hold it into place might have a little dirt into the plunger.
SOURCE: How many horns does a 2008 Mariner have and where are they?
tried to find the wiring diagram..... it only tells me components on the one i found and it states horns... plural.... look between the radiator and front grill... the horns should be located there. i would suggest that to activate both you might have to hit both switches on the steering wheel at the same time.
SOURCE: no power to tow wiring harness
hello, if the vehicle came with factory towing, i has the relay already....sometimes they ship however without the fuse. the fuse should be behind knee panel on driver's side labed TOW or TRAILER good luck, marty
SOURCE: what tool do i need to replace front brake pads on 2008 mariner?
You Will Need A 13-14 mm Wrench for Caliper Bolts .A Large Flathead Screwdriver to Spred open Caliper/Shoes to Remove Caliper from Rotor,
After rhis you Can use a LARGE "C" Clamp to CLOSE Caliper Piston.
SOURCE: how to replace the defrost motor in my 2008
Thanks for using FixYa.com!
DON'T REPLACE THE MOTOR!!
The Motor is fine, the Blower Motor RESISTOR, not the Motor itself, is defective and must be replaced.
When the Blower Motor Resistor fails the Blower Motor will only work on High.
Let me know if this helped, or if you have additional questions: feel Free to contact us at FixYa.com!
149 views
Usually answered in minutes!
×