If you press any of the switches you will hear the motor but the seat don't move
The gear on the track has more than likely sheared from the motor. Unfortunately, the only way to fix this is to replace the power seat assembly. You can get one at a local salvage yard and bolt your original seat to the power assembly so that it will still match.
SOURCE: how to change key switch in 84 monte carlo
u got to take off the stearing wheel and u got to take the blinker switch off witch is about 3 screws and u should b able to c the tumbler take the pin out then it should come out
SOURCE: Power seat not moving front to back, everything else works
woman with a hammer fixed 2004 Rainer! Had same problem. just tapped rear runners with hammer and it broke loose. Works fine now!!!
Hope it works for you.
SOURCE: Power Seat Control does not move the seat front or back
Try tapping the power seat frame with a hammer to unbind the motor .
SOURCE: '96 Toyota Land Cruiser (LX 450)- Power Seats won't go in reverse
Well what I saw when I pulled my seats out of my 97 LC was that the worm gear on the bottom of the track had lost some tread. (its plastic) also, there is a cap that screws in to the end of that gear to hold it in place, so when you reverse the seat, the gear moves if that cap falls out of place ----small plastic cap fell out in mine. The whole rail system is like $300 at Toyota but i found a website that sells the cap and the gears for $20. I will try to post it tomorrow-for the time being, you can take the seat out -be sure to unplug the electronics, and use a wrench to manually move the seat back and then put it back into place
SOURCE: 2000 monte carlo blower switch works on only #5
Not the board. It's you blower motor resistor. It melted.
121 views
Usually answered in minutes!
×