Break lights no longer work. i changed the fuse and it helped for a bout a minute. what can i do

The fuse my have blow when the bulb did, check and see if you have power and ground at the dome light, if so, check the new bulb for continuity , if not, check the dome light fuse.

I would be looking for an overload switch in the ignition circuit of a faulty relay or loose fuse

Could be a number of problems. First, check and make sure the bulbs are not blown, that is if the brake lights and tail lights are the same bulbs. If it's not that, check the fuses for the tail lights/driving lights. From there, it could be a problem with the switch or wiring.

Check brake light switch by brake pedal Might be burned out

test the wires that come from the break pedal, to the break light, it might be a break in one of the wires. or you might just need to replace the light bulb..

i have had the same problem whhat i did was take off the wheels cleaned everything with break cleaner then ssprayed some in the brake cilinder and has worked fine for me

make sure u have enough antifreeze (coolant ) in the resovoir and bleed all the air out of system. do this by;letting engine run till good and warm no t over hot,then stop engine (make sure resovoir is full or a little over full)leave for about 35 to 40 minutes and see if coollant level has droped(it should this is normal) refill and repeat proscess over and over untill the coolant level stops ,u will notice it will take longer and longer for engine to warm up this is also normal then start engine and watch temp ,so it dont over heat,wait for fans to come on if they dont try a coolnt sensor and repeat this over again/thermastat is also some thing u can change(may be when u change coolant sensor/check fan relays and fuses before proceeding with all these remidies

you prob got a trailer plug prob bad wires if not tail lights run through turn signal switch tell fix ya bout me ok

flasher located at bottom of fuse box its round bout the size of a pop bottle lid,hazard flasher located at top

try changing one of the buls and see if that one then works