20 Most Recent
2004 Audi TT - Page 2 Questions & Answers
Brake spongy
get a buddy, maybe some beer, and bleed the brakes. one person pumps the peddle untill it is hard to push in, the other quickly and slightly opens the bleeder valve, if the person pumping the brakes foot hits the floor, the bleeder valve was not closed quick enough. its a litle tricky the first round. but to open and close in one motion is the ideal way. and this will involve shooting brake fluid out. protect your eyes and paint on car.. hold a rag over the top or slip a small hose over the bleeder valve to redirect the direction of the fluid.. or take it to a shop.
10/29/2013 1:45:31 AM •
2004 Audi TT
•
Answered
on Oct 29, 2013
Key will not turn in door lock
I would try to spray penetrating oil into the key hole and work the key in and out a few times. The cylinders don't get used very often so it is probably stuck.
1/6/2013 1:08:04 AM •
2004 Audi TT
•
Answered
on Jan 06, 2013
Esp light comes on after long journey
Hi there:The "ESP" system helps correct oversteer and understeer by breaking the inner or outer wheel as needed to get the car back on a straight path. When the light flashes the "ESP" system has detected this condition and has momentarily engaged.The fault can range anywhere basically from simply a failed brake lamp switch to anything like a failed wheel speed sensor,or brake pressure sensor etc. Check first to make sure you didnt accidently push the ESP on/off button on your dash which would cause this light to come on also. If thats not the case then you will have to have the code or codes read in your ESP control module (computer) to see what code or codes are set to be able to diagnose from here.Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.Thank you for using FixYa, have a nice day.
8/17/2012 10:04:53 PM •
2004 Audi TT
•
Answered
on Aug 17, 2012
Hi I need to reset
The sequence of programming for Audi radio is:
1. Push simultaneous "SCAN" and "RDS" keys until on the screen will appear "1000" displayed.
2. Release keys. No more push on "SCAN" and "RDS" keys because otherwise number "1000" will be considered as first safe code attempt.
For example: we have the security code "5079". Then:
3. By the no.# 1 key you will set up the first safe code digit. Push 5 times on the no.# 1 button. The "5" number will be setted.
4. By the no.# 2 key you will set up the second safe code digit. Push 10 times on the no.# 2 button. The "0" number will be setted.
5. By the no.# 3 key you will set up the third safe code digit. Push 7 times on the no.# 3 button. The "7" number will be setted.
6. By the no.# 4 key you will set up the four-th safe code digit. Push 9 times on the no.# 4 button. The "9" number will be setted.
7. Then push again simultaneous "SCAN" and "RDS" keys for confirm this safe code. On the screen will be displayed "SAFE" notice. Release keys! For few seconds a radio frequence will be displayed.
The radio is now ready for use!
8/12/2011 8:19:25 PM •
2004 Audi TT
•
Answered
on Aug 12, 2011
Not finding what you are looking for?