20 Most Recent
1996 Chevrolet Beretta Questions & Answers
1996 Chevy Beretta. What is the best way to reset the computer in it please?
Question edited for clarity.
Question moved from Best Computers to model category.
You don't say WHY you want to reset the ECM?
Remove both battery leads for 5 minutes. Touch the negative and positive leads together for 30 seconds. Reconnect the positive lead, reconnect the negative lead. Make sure the key is in the ignition but not turned on. You may have to reset the alarm if it has one. You may need to input the radio code.
How do you replace heater core in 96 beretta?
The heater core is located under the dashboard inside the car. right behind the radio. theres 2 covers that control the flow of air. the first is relatively simple. remove the bolts and pull it out, if it resists try to find what it is hung up on. then the second cover is what covers the actual heater core. remove that by removing the screws and it should come out also with relative ease. then on the outside of the car, almost to the bottom of the firewall, there are two hoses, one is your ac the other is your heat, remove both of those and the heater core should be free other than four screws holding it in the car, remove those and it should come out. replacement is the exact opposite of removal.
How do i fix a p01133 error code on my 96 beretta
DTC P1133 HO2S Insufficient Switching Sensor 1
What other codes , need to diagnose those codes before P1133 !
Important: If any DTCs are set (except P1133 or P1134), go to those DTCs before proceeding with this diagnostic table. If the vehicle is misfiring is there a DTC P0300 Engine Misfire Detected code ?
How to remove intake manifold on a 96 Chevrolet Beretta Z26
This is not the kind of job that can be described here. If you do not have a manual, special tools and more importantly the experience I would advise you take time to watch some youtube videos and find a baretta owners forum and get to know the people there.
1994 bretta low coolant light came on but level is
Hello rickwyatt100: My name is Roger and I will help you. If you are sure the coolant system is full?Disconnect the low coolant sensor. Turn the ignition switch to the run position. Is the low coolant light lit? If No, Replace the low coolant sensor switch. If yes you need to check circuit 69 for a short to ground. If the circuit is ok replace instrument unit for repair or replacement. Should you need further help please just ask. Please rate the answer. Thank You for using Fix Ya. Roger
1996 Chevrolet Beretta. Where do I add freon?
attach the recharge kit to the valve under the blue cap on the lower front of the vehicle, between the engine and radiator. The hose end from the kit, will only fit the proper size fitting on A/c system. The right fitting is there! Good-Day!
Www ehow com
remove door panel, unplug and unbolt old mirror, replace with new mirror.
Not finding what you are looking for?