20 Most Recent 1995 Chevrolet Beretta Questions & Answers

To troubleshoot this types of problem,click the link below :----http://howtobyme.blogspot.in/2012/02/heater-blows-only-from-defrost.html --------Go through the procedure to confirm the issue.------Engine Overheats and heater blowing cold?http://howtobyme.blogspot.com/2011/11/engine-overheats-and-heater-blowing.html---------Heat blows cold on drivers side and hot on passenger side?http://schematicsdiagram.blogspot.com/2011/12/heat-blows-cold-on-drivers-side-and-hot.html-----------This will help.Thanks.

No only 96 up with OBD 11 are programable.

Ground problem. Check the battery cables and clean them. Make sure you have a battery to body ground and an engine to body ground.

Here's a link to your head bolt torque. Repair Guides Engine Mechanical Components Cylinder Head AutoZone com

I don't know the exacts on this, but if you remove the door panel, you will see a window regulator. Clean out all of the glass from the door first. roll the window back down to the middle and you will see the mounts for the old glass where it connects to the regulator. remove the nuts that go to that and remove whatever is left of your window. Go to an auto glass shop and get a replacement window. Most likely they will already have your glass ready to go. Just take the new glass and at an angle slide it down into the door until it lines up with where it mounts to the regulator and re attach the nuts...roll the window up and down to make sure it isn't catching on anything and then put it all back together...you can easily do this yourself...it just takes time to do it right. Hope this helps you ...

install a new thermostat and make sure coolant level is up normal temp should be around 210 on gauge

look under the hood, there is a diagram on the veci sticker.

Depending on which engine you have (2.2L or 3.1L) so here's both. First is 2.2L sec pic 3.1L

Hi Jacob,here's a link to some repair guides,it's a must have to keep your ride running and it will save you a ton of money. List Repair Manual General 1995 Chevrolet Beretta Reilly Auto Parts

some of the fuses are only powered up when the circuit is turned on. if they aren`t there will be no power supply to the fuse.

It fits every GM midsize car.

Your description isn't entirely clear, but it sounds like there may be a problem with the lockout solenoid on the shift handle, or possibly a stretched or seized shift cable. If the handle moves freely, but you are not able to move the car when it appears to be in neutral, the cable probably needs to be replaced. If the car drives for a short while but then loses power and has to be restarted, you may have a faulty torque converter or transmission computer. If the shift handle won't move sometimes, it may be due to a faulty lockout solenoid or brake pedal switch.