20 Most Recent 1992 Chevrolet Corsica Questions & Answers


Sounds the EGR valve and EVP sen is bad even if you tested it. The EGR valve cntrols idle and if carbon up will make the car stall or idle high and low (rpms going up and down) This was common on all cars during that time. I would say replace the EGR valve and senosr. This should take care of the problem. One more thing have the fuel pressure check on the car.

1992 Chevrolet... | Answered on Aug 10, 2018


You need to test the control module for the engine and see if any codes for this issue are in memory. You can do so by following the instructions at the link provided. FAQ How to read older GM codes for free

1992 Chevrolet... | Answered on Jun 30, 2017


BUENOS DIAS QUIEN ME PUEDE AYUDAR
Tengo un problema con mi carro (CHEVROLET CORSICA 92) que ayer me comenzo un Marcar Una luz roja en el tablero (INFL REST) y no se kita, pues hoy ya Causo Algo de pedo apagandome el carro, y Ahora Cuando Se apaga Y lo vuelvo a prender le entra una falla y Las revoluciones se bajan al rato de andarlo y se Terminales apagando.

1992 Chevrolet... | Answered on Jun 05, 2016


did you clean your engine coolant system
you might have some dirt inside the block so the coolant can not pass
and check your temp sensor it is possible it could be defect.

1992 Chevrolet... | Answered on Oct 21, 2014


Most likely a blown fuel pressure regulator. Located on the fuel rail near the throttle body. Remove vacuum hose and turn key on, do not start, and look for fuel exiting the vacuum port. If it is, replace it.

1992 Chevrolet... | Answered on Dec 22, 2013


inside door pull corner piece behind mirror and you should see bolts or torx screws. if electric the same but also follow wiring to unplug

1992 Chevrolet... | Answered on Nov 07, 2012


You MUST bleed all air from the lines . There is a bleeder near the air filter and one by the belts . If it continues to over heat , then u have a blown headgasket .

1992 Chevrolet... | Answered on Sep 17, 2012


you can only push this detent pin in when ignition is in on position try to put key that snapped in and wriggle it around to try and turn ignition to on position so then you can remove barrel
if cant turn need to change whole assembly by un doing shear pin for clamp that holds whole assembly on steering column or do what some lock smiths do drill out old barrel slowly and going up in drill sizes until barrel comes out from housing without damaging housing

1992 Chevrolet... | Answered on Aug 23, 2012


better clean the fuel pump

1992 Chevrolet... | Answered on Aug 01, 2012


yes you can. use carb cleaner. and its not a cheap part on this car it is 150 bucks because it is an electric egr.

1992 Chevrolet... | Answered on Jul 25, 2012


in the gas tank

1992 Chevrolet... | Answered on Jun 29, 2012

Not finding what you are looking for?
1992 Chevrolet Corsica Logo

134 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Corsica Chevrolet

  • Corsica Chevrolet

Most Popular Question

fuel pump

  • Cars & Trucks
Loading...