20 Most Recent
2009 Hyundai Accent - Page 5 Questions & Answers
Rims. well i was wondering if i will need a tire
If you have 3o-35,000 miles on your car, you may be due for new tires. Tires will ware out, you may have hit a few pot holes,or had a few flats. Manufacturers usually warrenty tires for new cars for about the same mileage I stated above. If your tires are waring well possibly you only need a wheel balancing. Take your car to a tire dealer in your area , and have them check for you. GOOD LUCK.
2009Hyundai Accent. Where is the
Be careful !!!! Look under the frount of the car you will see a black thing that it looks like a pan with a bolt in it.Take out the bolt and your oil will come out .After it drains out wipe the bolt hole and bolt off and replace and tighten good and snug as in thight.After that find the oil filter probably in front or the back of the motor but take it off and wipe off where your filter was,make sure the rubber gasket is not stuck on the motor, then repace filter.Your best deal is to let someone else do it .You really dont save alot by doing your own ,they have insurance if something happens and believe me anything can cause it has with me and I have changed oil 39 years.GOOD LUCK!!!
CODE B1102
Hi the error code is B1102 = Battery voltage low
Hope this helps
Steve
Break lights stopped working in
This YM (Year Model) is probably still under warranty. Make the phone call to your nearest Hyundai Service Department & ask the question -- you could get it diagnosed & repaired at no cost. BTW, the switch is located under the dash at the articulating arm of the brake pedal.
I have an 09 accent
Vehicle is still under US warranty - Take to Authorized Hyundai Service Department & have it diagnosed/repaired under warranty (was this vehicle in an accident?... if so, contact Insurance agent for proper instructions).
There seems to be a
Best case senario is that you have a loose accessory belt. Worst case would be noise is comming from the timing belt tensioner or idler pully. If that part fails it could destroy your engine. Take your car to a mechanic ASAP and have it diagnosed properly. If it is just an accessory belt it won't be expensive , If it is a problem with the timing (cam) belt , it will cost some $$ but could save you from having to pay for a NEW ENGINE.
How do I change the
the bolt inside the idler pulley needs to be loosened and there's a jack bolt that the pulley moves in the slot with be causous as the bolt may tighten the belt by looseningthe bolt.
I have new Accent Excutive car, i just notiec that
putting a tube inside a tubeless tyre is a cheap way of fixing a puncture,BUT DO NOT EXCEED 75MPH,as, if the tube gets punctured,you could lose total control of the car......If you get a puncture with A TUBELESS TYRE YOU SHOULD ALWAYS replace it (how much is your life worth)Tyres have written on the wall wether they are tubeless or not.DO NOT MIX THEM,lastly NO MANUFACTURER fits tyres with tubes for road use.
Installation of OEM or OEM equivalent fog lights Hyundai Accent
How to Install Hyundai Accent Fog Lights.
The procedure is as follows:--
The fog lights on your Hyundai may need to be replaced every year because fog lights burn out over time with regular use. The part number for the replacement fog light is stamped on the base of the old fog light. Replacement fog lights can be purchased from most auto parts stores or directly from Hyundai. Once you have the new light, you'll need to know how to install it. Installation should take no longer than 10 minutes.
- 1)Open the hood and remove the screws on the back of the fog light housing.Pull the fog light housing forward from the front of the vehicle.2)Remove the electrical connector from the back of the fog light ballast.3)Remove the bail wire holding the fog light in place.Remove the fog light by pulling it straight out. 4)On some Hyundai vehicles, you will need to push in on the fog light and turn it counterclockwise and then pull it out of the housing.5)Align the tabs on the replacement fog light with the notches cut into the housing on the Hyundai's fog light assembly.6)Insert the fog light and, if necessary, turn the fog light clockwise to lock it into the housing. Replace the bail wire to hold the fog light securely in place.
--------------
Do not touch the glass portion of the fog light as the oils from your hands can cause the glass to explode inside the housing.
This will help. Thanks please keep
updated.please do rate the solution positively .thank you for using fixya
Not finding what you are looking for?