Mtd Garden - Recent Questions, Troubleshooting & Support

You might be able to find what you are after here >> <<


Mtd Garden | Answered on Jan 07, 2020

not adjusted correctly -wrong cable -wrong belt on deck

Mtd Garden | Answered on Oct 08, 2019

Check with if they cannot answer try eReplacement

Mtd Garden | Answered on Oct 08, 2019

make sure the vent in the gas cap isnt plugged up. test by loosening it a bit to see if it cures your problem

Mtd Garden | Answered on Oct 07, 2019

sounds like the drive belts may be wore out and need replaced. also the tension pulleys may be binding. clean and spray some lubrication spray on them that may help some.

Mtd Garden | Answered on Sep 20, 2019

Request the wiring diagram directly from Huskee.

Mtd Garden | Answered on Sep 19, 2019

Dont know the exact lash for the MTD OHV engine but most small engines of this type will work just fine with both intake and exhaust at 0.006 inches. Make adjustment with piston at TDC compression stroke.

Mtd Garden | Answered on Sep 19, 2019

Hi Nick,
This may be the same diagram you already have, but this is the manufacturer engineering drawing for that deck.

MTD 13RN771H729 Yard Machines Lawn Tractor 2007 Home Depot Deck Assembly...

Mtd Garden | Answered on Aug 27, 2019

Replace the coil

Mtd 22" Yard... | Answered on Aug 22, 2019

I had the same problem with the shifter cable braking.They were very expensive to replace.My cable tube(the outer part with the adjustable nuts) was still good.The cable itself was broken.I went to the nieghborhood hardware store and bought a length of cable of the correct size.I then used an electrical eyelet at each end (the eyelet has place to slide wire into it then it get crimped to hold the wire,also it has a hole in it so a screw or bolt can go through to hold it in place.I connected an eyelet to one end of cable,2nd I fed the cable through the tube,3rd, I put a screw through the hole were the cable connect to the shift linkage(@ trans),4th placed the eyelet on the screw 5th then placed the nut on the screw .At end of cable where shift nob is I placed an eyelet where the cable originally went,Pulled the new cable through taking out ALL the slack,Marked cable then crimped it,placed nut on screw.It works like new.MAKE SURE THE LINKAGE and SHIFT NOB ARE IN NUTURAL POSITION

Mtd Garden | Answered on Aug 21, 2019

Try Replacement they have videos that will help you

Mtd Garden | Answered on Jul 17, 2019

Not finding what you are looking for?
Mtd Logo

3,942 questions posted

Ask a Question

Usually answered in minutes!

Top Mtd Garden Experts


Level 3 Expert

775 Answers

Joseph Mueller
Joseph Mueller

Level 2 Expert

346 Answers


Level 1 Expert

32 Answers

Are you a Mtd Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides