...module and retry for spark. If still nothing, try using a thin business card for a gap gauge between the flywheel magnets and the module poles. Insert the card, then loosen the module screws--and ...
...the card and recheck for spark. If still nothing, try removing the stop-switch wire from the module and try for spark again. If nothing again, replace the module. Install as above. Hope this
...module. If you got good spark in the first test, then pour some fresh fuel mix into the plug hole and try for start--if it pops a few times, then look to the fuel/carburetor system for service. Check ...
...module coil and try for spark again. If still nothing, try setting the module pole gap by turning the flywheel magnets under the module poles, insert a thin business card into the gaps, loosen the ...
Question about 350 18 Inch Gas Chainsaw 52CC Fully Assembled Brand New 18"
close up further. Use a fresh spark plug gapped at 0.020" and try for spark. If nothing, replace the module. This gets around measuring resistances while trying to evaluate the module. Hope this helps
...module body and retry for spark. If you get spark, check the switch wire and the switch itself for grounding. If still nothing replace the ignition module using a thin business card for a gap gauge. ...
module and try for spark again. If still nothing, replace the module using the above procedure to install. If the first test produced good spark, then pour a little fuel mix into the plug hole and try
Question about 125bvx Hand Held Blower Vac
...spark plug wire. How do I replace the module. What is the setting between the flywheel and the module? Thanks, Chuck husqvarna model 125b weed trimmer what spark plug do i use manual says rcj-6y in ...
...the spark plug and put it against the head and there was no spark. Just wondering if anyone had any ideas. Check the ingition module and gap between the module and flywheel. use a 0.25 feeler ...
Question about 125bvx Hand Held Blower Vac
...module. If still no spark, measure resistance of ignition module secondary winding (sparkplug wire to ignition module metal armature).Typical 5k to 8k ohms or more. Comment below for further ...
Usually answered in minutes!
529 Questions
514 Questions
473 Questions
353 Questions
122 Questions