Questions & Answers for: Craftsman remove bowl

...remove bowl and work float to flush trash out and you can remove float and remove needle valve and replace. That, and the float could have a small hole allowing fuel in, and is sinking in the fuel in ...

...sure the hole in the float bowl nut are clean. If the problem persists after draining the float bowl nut you will have to remove, dis-assemble and clean the carb with compressed air and carb

Remove the bowl and clean it out with clean rag or paper towel. Use some carb and choke cleaner to spray the carb. Reattach the bowl, and tighten the bolt making sure the ruber gasket between the bowl

...remove the bowl. It takes a very thin 1/2" wrench to reach the flat sides on the solenoid and not mess anything up. I use an old tappet wrench but I don't know if they even make those anymore. If you ...

...remove the bowl (sometimes the bowl is slightly sticking and needs a slight bump)and see that the operation of the float moves up and down with no restriction of movement. See if there is any dirt in ...

want to remove bowl from bottom of carb but has elec. solinoid attached how do you remove carb. bowl? It unscrews. Disconnect the wire and unscrew it.

...bowl. Remove the gas line from the carb and plug the line with a phillips head screwdriver. Remove the bolt in the bottom of the bowl and carefully tap on the bowl to loosen it without damaging the ...

...remove the float bowl by turning the nut at the bottom. There will be some fuel present in the float bowl, so be aware of that. When the bowl is removed, the float will have dropped down and be ...

...I fix this? Sounds like the float inside the bowl is sticking open. Remove the bowl, remove the float and shake it. If you hear any kind of sound, the float needs to be replaced, it has a hole in

...Remove bolt and pull bowl down slowly. Look in bowl to see if there is water at bottom under gas.To be sure dump out fuel and clean out bowl with clean rag and some air. Next place a small piece of ...