...surge and knocked out my printer. can the ac power adapter be replaced for this printer? Power surges on these can take out the main board (unnumbered), modem(3), and power supply(4), approx 150
...off unit unplug power cable for 1 minute reset the power cable open front door press and hold the reset button under the lights turn the power on printer should then be reset Same experience --
...press & hold the power button on the printer when unplugged from the power to release the static power of the printer.. connect the printer directly to a wall jack and power it on.. Good Luck
Question about MFC-5840CN All-In-One InkJet Printer
...power supply by plugging the printer in 220volts inlet. I need to replace the power supply. please help to locate the power supply. Cheaper to replace the machine than buy a power supply - unless you ...
...off your printer. Remove power cable from printer. Open upper cover remove cartridge and then re-install. Wait for 5 minutes. Connect power cable again and restart your printer. It will work
Question about DCP-135C Flatbed Digital MFC All-In-One InkJet Printer
...power button until the printer powers off. Unplug the printer for several minutes and then plug the pirnter back in. This will do a reset on the printer. Allow the printer to fully cycle in the power ...
Question about HL 2140 Laser Printer
...solution. To prevent power surge problem you need to connect all your computer equipment and printer to a power board with a built-in surge protection then plug this power board into the mains
printer to an AC power outlet/socket that you know works. Do not connect any other equipment to the outlet/socket. Do not connect the printer to an auxiliary power outlet on the back of a computer. Is
printer stopped working Hi, Please check it power cable or power board, if power section ok or working. Then check you printer connection or not. Check printer cartridge shot or not detect. Check it ...
Question about MFC-7440N Laser Printer
...a power regulator then try plugging it directly to the wall and see if the problem is solved. You might wanna check the voltage power of both the printer and the outlet before you go on with
Usually answered in minutes!
1,135 Questions
1,072 Questions
1,012 Questions
767 Questions
733 Questions