...ve installed two cables, both of which broke. You made mention of a metal part bending, is this the fork? You may need to pull the bell housing to check the operation of the fork, throw-out bearing ...
...a worn synchronizer or sliding hub. Another possibility I've seen a few times is a bent shift fork. This is usually the result of abuse or excessive force being applied during hard driving. ...
was hitting metal. either the slave or master cylinder is leaking air into the system and the shift fork is not pressing against pressure plate to move clutch
...oil seals of the gears of the transmission.Don't forget to check also the shift level and the shift fork of the transmission.check the said gears ,the shift fork ,the shift level and the oil seals if ...
...'94 mustang t5 manual bolted to a 302 engine in my 1930 pickup hot rod.does the clutch fork push forward or pull back towards the cab.i don't seem to have a pivot point to see which way ...
...will not have one, it has a cable that runs from the top of the pedal assembly to the clutch fork on the side of the bell
I have a 2000 mustang gt 5 speed that gets stuck in reverse, can you assist with troubleshooting? Check the cable and the fork
Clutch fork Replaced clutch, cable, quadrant and added firewall adjuster and still have tremendous cutch fork vibration. did you replace the throwout bearing with the clutch ? if so, then it could be ...
...fork most important but also need quadrant assembley I suggest you check for fluid in the resevoir as it sounds as if the slave cylinder developed a leak and lost the fluid. Clutch forks seldom if ...
...clutch is very new, you may as well replace it too, and the pressure plate. Examine the throwout fork very closely for cracks, as they can fail that
Usually answered in minutes!
706 Questions
694 Questions
653 Questions
589 Questions
617 Questions