Questions & Answers for: Husqvarna how do i adjust the mixture

...adjust the air mixture I am looking for a tool to adjust the air mixture screws. It appears to take a special tool? yes the EPA has mandated you be trained how to properly adjust the new carbs, Any ...

How do I adjust the mixtures? How do I adjust the mixtures on my Husqvarna 365 chain saw please? Is this helpful? Madsens.com http://www.madsens1.com/saw%20carb%20tune.htm The "L" adjusts acceleration

..., WANT TO adjust carb ,there is a idle srew ibelieve ,then 2 screw on blue and on red i believe ,i think the mixture is not leane enough i have to have choke on half way for it to run ,how do i ...

...mixture. So, turn the left screw, sometimes marked "L", counterclockwise to richen the carb. Adjust a very small amount at a time. Let it run a little, cut some wood, then adjust again, if need be. I ...

...adjust carb but haveing no luck what is the proper adjustment please help Hi, Gerald I will try to help. The high speed mixture screw basic setting is about 1 1/4 turns out from lightly seated ...

mixture screw. They are marked on the carb body, with the letter H or L . To adjust, remember the screw position before you do any adjustments. Start by turning the screw in (clockwise) all the way in

idle to half throttle, a H screw, this will adjust the mixture from half throttle to maximum throttle, and a I or T screw, this works on the throttle spindle and will increse the idle, not the mixture

sputters and puffs black smoke carb. mixture too rich. adjust as needed, to lean the mixture turn the mixture screws inward.

...adjust them to over come some underlying problem i.e dirty fuel, blocked air filter or dirty or blocked air filter. if the screws have not been touched this will be a good starting point, both screws ...

...mixture screw on the carb and adjust it counter clockwise to fatten the fuel mixture. That means it's not getting enough because when you take off the Choke you're giving it more air. So make sure ...