Olympus u-mini, lens is noisy, goes in and out then get blue screen with error codes d: 5E02 5F02 5E02 5F02 5EO2

Was not fixed. Do not have this specific camera.. Is a different Olympus.

Hello Jakub,
As you might already know that you are not the only one who is getting this error.. there are thousands of others with you .. If that makes you happy :D
This code is a troubleshooting service code for "malfunction of focus motor/sensor". It is a motor/sensor issue and is normally caused by sand or dirt in the lens cover mechanism. Try to turn on camera while holding it with the lens pointing up.
You might even try hitting the camera on your palm in that position (by hitting, i don't mean a real HIT .. be sure that you are gentle not to break the camera).
If that doesn't work then try this... when the lens is trying to come out and cannot come out completely then you can assist the lens by pulling it out manually (once again, understand that its a delicate camera and I don't want you to show how powerful you are by pulling it with all your mighty vigor.. be hard and gentle at the same time .. I hope you understand what i mean)

Please let me know if any of the above steps work for you and do rate the solution :)
All the best.

Regards,
Srinivas

try this and see if it works for your problem as well. this is from another fixya post.

error code is associated with the lens port... usually when the pressure against the lens when turning on

control panel problem... could be lens port... but needs to go to repair

hi alexandra olympus cameras are know for having a few lens problems when ever a blue screen comes on the camera is faulty it sounds to me like you have some dirt or dust in the lens i have seen this problem a few times hope u get it sorted goodluck

This need to go back- under warranty or for replacement - contact vendor or your local Olympus site.

turn on the camera with the lens face up

The lens extension mechanism is probably damaged,
or the circuit that drives it.

It could also be caused by poor batteries or bad
battery connection

see my other posts on the same topic.

Martin

the lens open halfway, the picture on the LCD is blurry and one second after the lens close and an error appears of the screen saying "D: 5f08 5e02". what does this mean??? can you help me fixed this one??