E:62:02 error message on my sony camera - Sony Cyber-shot DSC-T77 Digital Camera

Error code 94:01 is an internal memory error. If you still get the error after reformatting the card or trying a different one, it's an electronic issue usually used by component failure and requires replacement of a circuit board within the camera.

Per SONY; To service the C:31 code, Sony recommends you do the following: Turn off the camcorder. Remove the battery or disconnect the AC power adapter for 60 seconds. Insert the battery or reconnect the AC adapter. Turn on the camcorder. If the error message appears, service may be required.

If there is error message on the display and blinking flash, try to initialize the camera. If the problem persists or there is no error message, there is probably no user solution, camera will have to be repaired by service personnel.

Hi,

Checkout this tip about digital camera error messages


Lens Errorfix for Digital Camera

heatman101

Hi,

The Error code indicates the Self diagnostic message of the Camera. This message can be clearly identified by the help of a Sony Authorized service technician. The

Error code 56 indicates an issue which can be resolved by the help of a service technician. This error code may be an issue with the Shutter mechanism. Try resetting the Camera by selecting the Reset Default option in the Setup Menu 3 option. Also, try removing and reinserting the battery after 1 minute. If not resolved, get the unit serviced.

Thanks.

A letter and number error code of E:61:xx , E:62:xx , or E:91:xx is an indication a malfunction has occurred in the camera. To try resolving any of these error codes, power reset the camera back to the original factory specifications.

I'll forward a link to a page where you can view the information about power resetting the Camera.

Please click on the link to open the page to view the troubleshooting steps.

http://www.kb.sony.com/selfservice/documentLink.do?externalId=C265373

Thank You!

this message comes up if you have dropped your camera. try tapping the device while the message comes up. if that doesn't work then you have to take it to the sony service centre to replace the lens array. it costs about 60$ to replace it.

clean brass contacts with qtip and rubbing alcohol. let air dry couple of hours. do the body and the lens. hope that helps

no, put gasoline on your camera and burn it....so that your problem on your camera will be solve..

the problem of your camera is the ccd image sensor...better go to the sony service center for replacing the image sensor..i know it is free for replacing that sensor cause that is one of the model that sony recall produc and the cover not open error message is a poor contact of the lens cover switch...