I have a prpblem with KM1018 it does'n started, appears message Kyocera and stops can you help me for this problem

some clue of 'make model (what it is)' helps, but here you go.


1:15
Installing the paper cassette on the FS-1061DN and FS-1041
YouTube · KYOCERA Document Solutions Europe 1 minute, 15 seconds
Apr 16, 2013
1:36
Installing the paper cassette on the FS-1220MFP, FS ...
YouTube · KYOCERA Document Solutions Europe 1 minute, 36 seconds
Mar 28, 2013 View all

Kyocera P6130cdn- "Cassette 1 Not Loaded" Message

Copytechnet https://www.copytechnet.com > kyocera-mita-copystar
Mar 31, 2021 - Re: Kyocera P6130cdn- "Cassette 1 Not Loaded" Message 3 small switches present. Press and hold 1 or more and check if motor turns on rear left ...

Cassette 1 Not loaded Error - Kyocera FS-4020DN
Apr 25, 2017
Miscellaneous Ecosys P6130cdn "Cassette Not Loaded"
Apr 20, 2022
Disable MP tray and for printer to use cassette 1 and cassette 2
Mar 24, 2021
TA351ci "no paper in cassette 1" - Copytechnet
Aug 1, 2022
More results from www.copytechnet.com

It is resettable to enter simulation so .....
Press and let down "Clear / Stop", "Start" button on the left to darken or clear, then "Stop / Clear" "U163", "Start" appears "CLE" and there you hit "Start" other time and now.

problem with doc feeder or duplex unit causing problem

hold down the stop button the start button and then left exposure button, release them and press start .type code 163 for clearing fixing error

Try the feed tires in the tray first. More than likely the paper is not being picked up and causing jam message. The separation roller also has a hub on it to prevent a second sheet from feeding. Sometimes these start to lock up ,a little oil on the hub sometimes relieves some of the tension.

This message often shows up when the memory is full from one document (normally a large file) to fix it you have to add external memory

you need to call a kyocera service center... or contact kyocera customer support... customer support is free... service center might not be...

I’m happy to assist further over the phone at https://www.6ya.com/expert/norman_d2fa496dce30c65d

Hello sir; You need to do a reset procedure;
press these keys in order and keep hold them down, "stop/reset" "start" "left copy density", press "stop/reset"key again, then enter U163 press "start" twice to clear.

Hello sir; your machine temperatur too high need to reset the procedur as follow;
1, press "stop/clear" key, "start" key", and left copy density key.
2, press "stop/clear" key again.
3, enter U163 press "start".
4, when screen display "CLE" then press "start" again to reset.

Your drum unit is not seated correctly. Look inside for a bent drum ground clip.