Alert ! Unsupported memory configuration. please populate DIMM1 strike the f1 key to continue, f2 to run the setup utility press f5 to run onboard diagnostics

You need to give more details on your system. What type and how old.

change the battery inside the computer on the motherboard then fix bios setting and them save and reboot should work fine then battery dead

Run the onboard diagnostics and pay attention to the screen. Let me know what it says when it gets to the HDD test.

Hi, You can try power drain first. Power off system , disconnect power and press and hold power button to discharge stored power, then remove memory module 1, then reseat it by inserting it with the levers extended to the sides and press down with thumbs until the levers snap in place vertically on their own. if no change, replace module. \quote While reseating the Memory Module please Handle with care. Quote/

Certain models talk to a chip in the adapter, sounds like this one has gone bad. At this point you can live with, buy a new one or pick up a used. This is a fairly popular model and you should be able to locate one from a dead laptop.

This seems the Hdd is Not getting Detected , First thing you can try is inserting the hdd back in the system and then get into Setup Utility by Pressing F2 and check whether the hdd is listed or not , If the HDD is not listed that means HDD has gone bad .you need to get a new HDD

Clear the CMOS ram memory.

No bootable device usually means that your hard drive has failed. It is either not connected properly to the computer or the drive needs to be replaced.

Please let me know what is the make and the model of the pc that you are using.. Also, go to the bios, under boot menu, make sure that you have hard drive as the first boot option.. For further queries please get in touch..

Strike F2 to go to the bios to run the setup utility

Don't touch anything , save and reboot

If primary hard disk still not found

reboot press F2 to re-enter the bios

Look for Auto Detect Hard Disks

if the computer shows a hard drive is detected

set the drive to LBA if possible

save and reboot



Az.