Old Maytag washer LA182 motor replacement

If a receipt or other paperwork is not available, the age of a Maytag washer can be found by looking at the serial number. The last two characters of the 10-digit number indicate the year and month of manufacture. A Maytag washer serial number is 10 characters long, with the last two characters being letters.Mar. 26, 2021

How can I tell how old my Maytag washer is? - AskingLot.com

If a receipt or other paperwork is not available, the age of a Maytag washer can be found by looking at the serial number. The last two characters of the 10-digit number indicate the year and month of manufacture. A Maytag washer serial number is 10 characters long, with the last two characters being letters.
Mar. 26, 2021

How can I tell how old my Maytag washer is? - AskingLot.com

could it be the thermasat are all the wires connected

transmission out buy new washer cost to great to repair 15 year old washer

Sounds like the timer motor may be dead. Can you hear it ticking when it is on or can you see the gear on the timer motor shaft turning when it is running? If not then the timer should be replaced.

these washers have a defective motor right from the box, yell louder.

there should be a belt tensioner on thebelt path check to be sure the belt is not slipping

Hello tomlyoung59

it sounds like the coupling between the transmission and the agitator is bad . You know the transmissions now a days have plastic gears in them and if you continue to use it may blow the transmission!
Speed queen is the only one I know with stainless steel parts in the trans and only 6 moving parts in the trans too.

How old is the washer?

If the appliance is 10 years old or more you it may not be advisable to put good money into bad!
New appliances are so much more efficient today that they can save you a lot of money in energy!
Water,Electric and detergent! And put money back in your pocket!
The new appliance will pay for itself in only a few years!


Bless You ngafm
PLEASE GIVE ME A GOOD RATING BEFORE YOU SIGN OFF

Thank You

It sound like Transmission Problems,Bury it and give it a Decent Burial, Dont Forget to Give Thanx.....ttech

pull the power plug for 15 minutes, then plug back in...same problem? tried adjusting temperature control knob (thermostat)? if yes to both questions, freon has escaped out of loop or faulty thermostat. Attempt force start of compressor with jumper clips: pull the power plug then find the two wires into motor and apply 120 VAC from jumper clips. If it spins, then faulty thermostat.