HOTPOINT model # RGB508PPH6WH Serial # RS143685R, no sprader plate on the oven burner. Is this normal?

Possible locations shown in article at the web link below:

https://www.hunker.com/13409112/how-to-find-a-model-number-on-a-magic-chef-oven


How to Find Model Number on Magic Chef Oven Hunker


Quoting the link above:

Step 1 Open the oven door. At the top, left-hand corner of the open oven, locate the model number tag.
Step 2 Check under the burners. Lift each burner on the stove off to see if the plate is underneath. Do this if the plate is not located on the inside of the oven.

change switch if there is no control if talking cook top elements
Infinite switch burner control need model number in full for quote

The burner is just a plug in unit. Take off the plate on the top and lift up on the opposite side for the burner from where it is plugged in. Give it a pull and it will come out just fine and plug the new one in.

The older appliances oftentimes have their serial numbers in strange places. For an oven, I would suggest the siding, the back (particularly in the bottom left corner or top right) and on the inside brim of the door. The only other place I have found a serial number was on the back on the top, under a metal plate. You can oftentimes go online or call the makers so find out where the number is hidden. For example, http://www.caesarsappliances.com might have where the serial numbers are online if you bought something there.

Hello there and thank you for choosing fixya
Ok normally the model number will be posted on one of the following
i have the diagram listed below for you ok this is for both gas and electric

An oven uses both 120 & 220 -- actually it would be 120 volts and 240 volts or nominally, 110 volt and 220 volt.

The 120 is used for the lights. The 240 is used for the heating elements.

A 240 volt breaker (nominally 220 volt) -- supplies both 120 and 240 volts depending on how the supply is connected to the appliance.

There will be a 240 volt (nominally 220 volt) breaker in the main panel for the oven. This is two 120 volt breakers side-by-side with their toggle switches connected together with a strap across the top of the toggles.

Charlie

your oven may be on a 3 phase connection that mean you have 3 supplies to it.
one phase may be running the clock and fan etc.
the other two maybe for the burnters .
check in your house fuse or trip switch box and ensure that all trips are on and or fuses are not blown. this is usually where your electic meter is located.

if this is the case switch the circuit back on, if the fuse goes again this may indicate a fault either in your home or with your oven. if so call in an expert to check.

warning. high voltage electricity is dangerous if unsure call out a qualifed electrician or speak to your electicity supplier for advice.

i hope this was useful

I'll need a model # & serial # from the oven, if you cant find it behind the control panel inside left then, remove the bottom panel where the burners are & look inside it. Last resort, send pictures of parts needed and I will match them up with my parts manual. [email protected]

My oven glowbar stopped working christmas morning. Yesterday we bought a whirlpool brand (igntr-oven #4342528) because it is twenty something dollars cheaper then GE. My husband installed it today. The only difference is you have to splice the wires (it comes with everthing you need) The first time he put it in it did not work because he had the wires backwards. He switched the wires and now its working fine.
My oven is two years old also.

Remove the old ones ONLY if you know what you are doing, and take them to the parts place with the modl # and serial # found on the tag plate!