No power at display!

cant give an answer since would need to test those components

Sounds like is what's happening:

Put in time, push start and unit runs for 2 seconds, relay clicks, unit goes off. Cook time on display goes off and clock time comes back.

That would be a bad upper interlock switch and charred connector. If so, see:

http://031d26d.namesecurehost.com/mwd/safety.txt http://031d26d.namesecurehost.com/mwd/disassembly.txt
http://031d26d.namesecurehost.com/mwd/doorsw.txt


We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

Magnetron and diode most likely. Need more info.

The owner's manual is here. On page 10 we find:

COOKING IN ONE STAGE
1. Press the POWER button; the Microwave and High
Cook indicators will light and “PL 10” will light in the
display.
2. Press the POWER button different times to set the
desired power; the display will show the percentage
you chose. If selecting power level 70%-10%, the
Low Cook indicator will light instead of the High
Cook indicator.
3. Press number keys to set the desired cooking time.
OPERATION(CONTINUED)
4. Press the START/+30SEC. button to start cooking;
the Microwave and one of the Cook indicators will
blink and the display will countdown the remaining
cooking time in minutes and seconds. It will beep
five times when cooking is completed.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

Sounds like the child lock has come on.

This addressed in your owner's manual. but if for some reason you don't have your owner's manual, you can download Maytag owner's manuals and installation instructions here.

Just enter your full model number.

If it's not the child lock, I would suggest a hard reset. Unplug the unit for a minute or so. Then plug it back in, set the clock and try again.

If that doesn't work,leave it unplugged for maybe an hour. Then let us know if the hard reset does not fix it.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

This sounds like the unit is defective and if I were you I would return for replacment!

On GE models, "SENSOR ERROR" appears on the display when:

• Using the sensor feature, the door was opened before steam could be detected. Do not open the door until stream is sensed and time is shown counting down on the display.

• Steam was not detected in the maximum amount of time. Use Time Cook to heat for more time.

The first thing I would suggest is a hard reset. Unplug the unit for a minute or so. Then plug it back in, set the clock and try again.

If that doesn't work, leave it unplugged for maybe an hour. Then let us know if the hard reset does not fix it.

Otherwise, your sensor may have failed.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

The first thing I would suggest is a hard reset. Unplug the unit for a minute or so. Then plug it back in, set the clock and try again.

You can download GE owner's manuals and installation instructions here.

We're happy to help you with free advice and we'd appreciate your thoughtful rating of our answer.

It should have a one year warranty, right? If so, Westinghouse should take care of it for you.

Contact Westinghouse Small Kitchen Appliances at 800-245-0600 or 800-947-3745 or see http://www.saltoninc.com/contact/contact.html

We're happy to help and we appreciate your thoughtful rating of our answer.