Magnum parts need channel selector for magnum delta force

I found it and so can you.Do a serch for magnum delta force radio. or go to www.bastardfairies.com

the "am" regulator is shorted. 2sa743 2sa1012or equivilent. less than $5 part..

i have a royce1-621 is there a way to put a 75 w amp in it ???

thanks [email protected] 708-599-1223

Its very easy on this radio because it has a built in frequency counter. I can't remember off the top of my head but its most likely band letter A, then turn the channel selector to 19. If you are on the CB channel 19, the frequency counter will read 27.1850.

If band A channel 19 is not 27.1850 then leave the channel selector on 19 and flip through the band letters until it reads 27.1850. once you have found it, that letter is the CB band. channels 1 - 40 of the cb band.

yes it sounds as if the diode has gone short curcuit. this is at the back or near the in put socket. the diode is black with a silver end. replace with same size this should sort it out.

cb shop temple, tx on yahoo search can see what i can find.

usualy that is a sign that someone was trying to get more channels then it already has which is imposible to get any mor ok check this web site cbtricks.com go to the radio information section go to m look for the magnum radio section look for the deta force you should find all you need there. good luck with your projec and god bless you.

james morgan
morgans electronics

Go to cbtricks.com look up radio information go to magnum use the wiring set up for the 357.

pin1 = mic audio,pin 2=receive, pin3= push to talk or transmit, pin5= shield.

cobra usually is white= mic audio, red= ptt, black= receive or speaker complete

Same as Omega
#1 Mic Audio
#2 Receive
#3 Transmit
#4 Up/Down for channels
#5 Ground/Shield
#6 13 volt