How to change pulse to tone
phone is 26943GE-2
SOURCE: pulse and tone
in GE:
TONE/PULSE DIALING
This adjustment allows you to select tone (touch-tone) or pulse (rotary) mode dialing. The phone is pre-set for
touch-tone use. To set to tone or pulse dialing:
1. Press and hold the program button for two seconds. You will hear a beep.
2. Press the *tone button to select Tone Dialing or press #pause to select Pulse Dialing.
3. Press the program button again. You will hear a confirmation tone.
SOURCE: Cordless telephone sw/from pulse to tone
Set the TONE/PULSE selection to Tone if you have pulse (rotary). If you don't know which
type of service you have (pulse or tone), check with your phone company.
To program TONE/PULSE for all 3 lines:
1. Press STORE/IN
2. Press 0 for PULSE or Press 1 for TONE
3. Press STORE/IN
4. Press TONE
To program TONE/PULSE for each line individually:
1. Press STORE/IN
2. Press 0 for PULSE or Press 1 for TONE
3. Press STORE/IN
4. Press LOWER
5. Press line number (1, 2, or 3)
SOURCE: Switching from pulse to tone.
Hi There, I had the same problem and what worked with me was by pressing the star button before the number, or if it works with u, by keeping a hard press on thre star button for 3-4 seconds
SOURCE: changing from pulse to tone dial
All phones have a sliding switch either at the bottom or sides of the instrument. The same is marked with "P" & "T" on either side of the switch, meaning Pulse or Tone. Shift the sliding switch to T for Tone or vice-e-versa.
SOURCE: Need to change phone back to tone dialing
Here's what the manual says: Changing the Dial Mode (Tone or Pulse Dialing) (HS1 only) Your phone can communicate with the telephone network in two different ways: tone dialing or pulse dialing. These days, most phone networks use a method called tone dialing, so your phone comes programmed for tone dialing. If your phone company uses pulse dialing, you need to change your phone's dial mode. If you don't get a dial tone or can't connect to the telephone network, follow the steps below to modify your phone?s settings: With the phone in standby, press and hold [cid/menu]. Press [vol/ / ] to move the pointer to select DIAL. Press [select/channel] to set the phone to pulse dialing. Press [end]. Return the handset to the base. The handset communicates the new setting to the base, and the base activates the setting on any other handsets. Hope this helps out. K
40 views
Usually answered in minutes!
I cant get the phone to stay on tone ,I have to be pressin tone to get the phone to stay in tone for the call only
×