Water reservior spills the water trying to push button to put in also the light is not working i got it for xmas modelodc440white do i have adefective pot? not satisfied with it i loved the old space

dry it out , put in hot attic , and hope it dries out.
PC are not water proof at all.
water kills the electronics, but if dried out can work (water)
spilled what, coffee, tell that was spilled.
Worst is COLA , drinks with 6 teaspoons of sugar per can. nasty.
push power button for 10 full seconds and release,
if fail
remove old bad now USeLESS huge battery now and then with AC power pack push power for 10seconds, release.
work now?

Radiator must be rodded out at radiator shop.

If you need further help, I’m available over the phone at https://www.6ya.com/expert/gene_9f0ef4df2f9897e7

Perhaps water pump problem. Have it check and replaced.

My wife's mini single cup B31 quit dispensing hot water into the K-cup. It would go through every stage and the pump came on but no water, no coffee. Try this: unplug the unit, take the drip tray off and lay the Keurig on its back, with the top opened so you can see the dispensing probe and the rubber ring that seals to the top of the K-cup. The dispensing probe is sharp, with two small channels, one on each side. (Be sure you can spill a little water when you try this) With a kid's water blaster, or a rubber bulb, squirt water up the channels on each side of the probe. Do this a few times, then try to run it normally.
That worked for me, and loosened the few coffee grounds that were plugging the outlet.

my dryer worked fine before xmas but washed a load of clothes and temped to put clothes in dryer and put it on right settings and pushed button to start it and nothing. We tried the breaker and shut everything down for about 5mins. and started it back up and tried the dryer again and still nothing had friend look at it and looked online and I think it maybe the start button myself.

Check the ank valve to make sure when you push it in that water is coming out. The reservior asm, (the tank bottom sits on this)is bad or the rod in the handle isn't pushing the reservior asm when you squeeze the trigger.

There is a valve at the bottom of the tank, push it in and see if it goes in and out ok. The tank sits on the reservior asm., a rod in the handle pushes it when you squeeze the trigger. You may have a problem with the rod not releasing or a bad reservior asm.

Check the valve at the bottom of the tank, push it in to see if it releases the water ok. The tank sits on the reservior asm. the rod inside the handle hits this asm to release the water. Watch the rod as you squeeze the trigger to make sure it is hitting the asm. If it is then the reservior asm is bad, if not then a problem inside the handle.

Maybe the reservior asm(#24). isn't working, when you push the trigger, it pushes a rod inside the handle to hit the reservior asm. so the water will release. Could be the rod isn't hitting the reservior asm. Maybe these pictures will help.