How do you clear all channels so i can put the channels that i want in it

if your using a dish then alignment should be fine if your getting some clear channels, maybe try a new install of all frequencies

You can clear all the stored information by resetting the scanner. While holding the 2, 9, and Hold, turn the scanner on. In about three seconds the display will show "CLEAr".

If you need a manual you may download a copy here.

Visit the new website siriusxm.com then turn on your radio and put it to channel zero get the radio id which compose of an alphanumeric characters. Then on the website refresh.siriusxm.com enter the radio id of your radio and then put your radio channel to channel 1 the go back again to the website after inputting the radio id click refresh after 5 to 15 minutes turn on to the channels that you want. Make sure that your car antenna is facing under a clear view sky.

Sometimes the input/channel for the DISH Network and the DVD are different, and if using the same for both, then you will get an unclear picture on one. If at TV1, the tv will need to be on channel 3 or 4, and possibly an input such as video 1 or 2. The DVD player may be on a different input, such as video 3, or even just on channel 3 only. If at TV2, the tv needs to on channel 60 or 73. When using the DVD, try putting the tv on channel 3 or 4, that is normally the channel that the tv needs to be on. Also, make sure that the DVD player is not on while you are trying to watch just the dish.

Becki Barned
DISH Network Customer Service

Unknown password--chassis ITC008 with TV off press and hold volume down on the front of the tv and clear on the remote for 5 seconds
need RCA remote with clear button

if you have indication of signal input for both channel you can go and reverse output cables of the speakers if the problem transfer to good channel change speaker cable-if you did not have input indication in the bad channel try to inverse input cable if it is cleared change your input cable if not you will have internal trouble and need service center to help.

Programming a frequency into a channel clears the previous channel entry, so there's really no need to "clear" the scanner for reprogramming. To eliminate an unwanted frequency, you can either press the LOCKOUT key to prevent the scanner from stopping on a specific channel, or you can "zero" a channel:

1. Press SCAN/MAN to stop
scanning.
2. Use the number keys to enter
the channel number (1-200)
you want to clear.
3. Press PGM. F=C appears.
4. Press 0 then ENT. The
frequency number changes to
000.0000 to indicate the
channel is cleared.

Need the manual for your scanner? You can download/print it here:

http://support.radioshack.com/support_electronics/doc69/69887.pdf

There is no global clear/erase function on the BC350C, but programming a new frequency on a channel automatically deletes/erases the old frequency. To delete an inactive or troublesome frequency, program "000.0" in that channel. Doing so will deleted the previously programmed frequency and set the LOCKOUT to ON for that channel. For more information on deleting frequencies, see page 27 of your operating manual.

Need the manual? You can download it here:

http://www.uniden.com/pdf/BC350Com.pdf

After you hold down the P button and the leds blink you put in 996 then the led's blink again. Once this happens all you do is put in the channel you want as a favorite, and then hit P For codes less that 4 or 5 digits you hit the enter key. ANd it isn't clear how many digits to put in for a channel with 2 digits but it looks like if you put in anything under 99 you will want to put in 099 098 097 etc etc... Hope that helps some

sound like you have a dirty video head, try cleaning the head with some isopropyl alchol. if it does not fix your problem, then you will have a bad video head. good luck