Questions & Answers for: how do you clear the scanner

...THAT THE DISPLAY SAY'S "CLEAR". ALL FREQUENCIES WILL BE CLEARED IN THE MEMORY!! THEN TURN Scanner OFF reinstall the BATTERIES, TURN BACK ON AND START PROGRAMMING!! THIS WAS FOR A "BC340CRS" ...

...clear the scanner before reprogramming. When you enter a new frequency it will automatically overwrite the old frequency. To clear unwanted frequencies you can program "0.0" into any channel to clear ...

...clear the scanner to re program it Programming a frequency into a channel clears the previous channel entry, so there's really no need to "clear" the scanner for reprogramming. To eliminate an ...

...if you cleared codes with scanner then try unhooking batterie for 2 minutes negative side then clear with scanner again and recheack scanner for code you must clear with a scanner there is no other ...

...and 9 keys down, turn the scanner ON. CLEAR will flash for about 5 seconds as the scanner clears its memory and restores factory settings. Do NOT turn the scanner OFF until CLEAR stops flashing. Bill ...

...scanner (clear a problem or keyboard lockup): - Tune the power OFF and then back ON. - Insert a pointed object (paper clip, ballpoint pen tip, etc) into the RESET opening on the side of the scanner ...

...scanner ON. CLEAR will flash for about 5 seconds while the scanner clears its memory. NOTE: Do not turn the scanner OFF until CLEAR stops flashing. Need the operating manual for your scanner? You can ...

...scanner To clear all information that you've programmed into the scanner you can perform a RESET to original factory settings: 1. Turn off the scanner. 2. While holding down the 2 and 9 keys, turn on ...

...CLEAR button again. The scanner should now be ready to accept programming. Need the manual for your scanner? You can download/print it here: ...

scanner ON. - CLEAr will appear on the display for about 2 seconds while the scanner clears its memory. - DO NOT power the scanner OFF until CLEAr disappears from the display. Need the manual for your