How to install door closer kit on imperial ir series

if thermostat is broken try fixing that

you may have a clog in the low burning ports..or the high one may be to large an opening..worn..

try a gas fitters shop for the parts

make sure the door is tightley closed for the temp to go down if theres any greese what so ever heat is attracted to greese.

Hi Aenriquez,

this is a monster cooker.
I have one at home in pieces, still waiting for refurbishing.
I dismantled the cooker sevaral years ago, so I do not know everything about it anymore.
But the mainsting here is, has it Flame Failure devices.
I think so, bu can not remamber that.
If so, then I would suggest that this item needs to be replaced.
I send you a link where you can find more.

I hope this helps, Dik
Imperial IR 4 S18 Restaurant Range at www ckitchen com

Check around, various stereo shops have "Insallation Kits" They come with all you need, and instructions on how to install

U can tries to clean the IR in the remote an the sensor box.Remove all electronics equipments close to the sensor box.Make sure the path is clear of clutter too.

Take the model number ( you didn't list it here ) to a parts house and tell them you need the door closer for the frig door . To install , remove the 3 screws holding the top door hinge located under tho top hinge cover , and lift door off bottom hinge . Remove all food items from door first . The closer should come with a lower hinge and the piece which attaches to the door . If not , tell them you need the door piece also. Or the kit may come without the hinge , but , with both the hinge piece and the door piece in the package .

HI, this will happen over a long period of operation time. This is repairable and, you will need to purchase an agitator kit from whirlpool or, an aftermarket circuit. installing a new agitator kit will fix this issue.

one or more of the main agitator components have become stripped or, damaged.

If you have a manual thermostat,(inside door, knob) your part is

#1175 OPERATING THERMOSTAT (HERMETICALLY SEALED REED SWITCH)

If you need the Hi-limit t-stat --

#1177 HI-LIMIT SWITCH

If you have digital control, with digital temperature control, the unit uses a probe.

#1094 FRYER CONTROLLER TEMPERATURE PROBE

Good luck, Mike